OPB980T51Z Datasheet, PDF (1/7 Pages) List of Unclassifed Manufacturers – Photologic® Slotted Optical Switch OPB960, OPB970, OPB980, OP990 Series

Photologic® Slotted Optical Switch
OPB960, OPB970, OPB980, OP990 Series
For parts built after 2004
Features:
• Data rates to 250 kBaud
• 24” minimum 26 AWG wire leads
• Choice of output configuration
• Choice of opaque or IR-transmissive shell material
• Choice of aperture
• Choice of mounting configuration
L
N
T
Product Photo Here
P
Description:
The OPB960, OPB970, OPB980 and OPB990 series of Photologic® photo integrated circuit switches provide
optimum flexibility for the design engineer. Building from a standard housing with a 0.125” (3.180 mm) wide slot, a
user can specify the type and polarity of TTL output, discrete shell material, aperture width and choice of mounting
configurations. OPB960 through OPB973 have 0.425” (10.795 mm) PCBoard leads with 0.320” (8.1 mm)
spacing. OPB980 through OPB993 have 24” (609 mm) 26 AWG wires.
All devices in this series exhibit performance over supply voltages ranging from 4.5 V to 16.0 V, and may be
specified as buffered or inverted with Totem-Pole or Open Collector output. Devices are also TTI/LSTTL
compatible and can drive up to 10 TTL loads.
Custom electrical, wire and cabling and connectors are available. Contact your local representative or OPTEK for
more information.
Applications:
• Mechanical switch replacement
• Speed and direction indication
• Mechanical limit indication
• Rotary encoders
• Edge sensing
• Sliding Door Automotive and Liftgate applications
Part Number Guide — OPB980 and OPB990 Series
OPB 9 X X X X X Z
OPTEK Assembly
Photologic™ Pnoto Integrated
Circuit Sensor Family
Discrete Housing Material:
6 — Base mount IR transmissive plastic discrete
shell with PCBoard lead termination
7 — Base mount opaque plastic discrete shell
with PCBoar lead termination
8 — Base mount IR transmissive plastic discrete
shell with wire termination
9 — Base mount opaque plastic discrete shell
with wire termination
Electrical Specifications:
0 — Buffered Totem-Pole Output
1 — Buffered Open-Collector Output
2 — Inverted Totem-Pole Output
3 — Inverted Open-Collector Output
All PCBoard Versions RoHS Compliant:
Z = Wire Version RoHS Compliant
Sensor Aperture:
1 = 0.010” [0.25 mm]
5 = 0.050” [1.27 mm]
Emitter Aperture:
1 = 0.010” [0.25 mm]
5 = 0.050” [1.27 mm]
Mounting Configurations:
L — Emitter side mounting tab only
N — No mounting tabs
P — Sensor-side mounting tab (Photologic side)
T — Two mounting tabs
RoHS
OPTEK Technology is TS 16949:2002 certified, any changes will be consistent with TS 16949:2002 procedures.
OPTEK Technology Inc. — 1645 Wallace Drive, Carrollton, Texas 75006
Phone: [phone] or [phone]
FAX: [phone] [e-mail] www.optekinc.com
Issue B 10/06
Page 1 of 7