ODISI-B5.0 Datasheet, PDF (1/2 Pages) List of Unclassifed Manufacturers – Sensor lengths up to 20 meters and gage lengths as low as 1.3 mm

DEFYING IMPOSSIBLE
KEY ADVANTAGES
• High definition strain and
temperature measurement system
for unprecedented visibility into a
design’s performance
• Low profile and flexible sensor can
be embedded within composite
structures and points
• Corrosion resistant, dielectric and
immune to EMI/RFI
• An economical alternative to replace
traditional point sensing systems
• No degradation of measurement after
high cycle count fatigue test
PRODUCT HIGHLIGHTS
• Sensor lengths up to 20 meters and
gage lengths as low as 1.3 mm
• Two sensing options: High-Definition
as standard and High-Speed
Continuous Fiber Gratings (CFG)
option for greater dynamic capability
• User selectable modes allow
configuration of sensor length,
resolution, and acquisition rate
ODiSI-B 5.0
Optical Distributed
Sensor Interrogator
The ODiSI is a 21st century
measurement system
specifically designed to
address the test challenges
of 21st century advanced
materials and systems.
The ODiSI provides more than 1000 strain or temperature
measurements per meter of a single high definition fiber sensor. The
high definition data can fully map the contour of strain or temperature
for a structure under test.
The sensor is flexible, low profile, requires no electrical source, and can
be bonded to sharply curved surfaces, embedded within structures, or
mounted directly to electrical surfaces.
An automotive frame is instrumented with fiber and then tested
under load. Test data is then superimposed on the CAD model.
www.lunainc.com | 3155 State Street, Blacksburg VA | Support phone: [phone] | [e-mail]