MOD-37-M Datasheet, PDF (1/1 Pages) List of Unclassifed Manufacturers – D-Sub Connector MOD Series

D-Sub Connector ^{MOD Series}
Description
D-Subminiature connector modules are used in industrial control as a connecting
interface between electronic and conventional components. They serve as the
signal conversion from D-Sub to screw connection. The D-Sub connector modules
provide user a convenient, quickly installed, and easily replaced input/output
platform for all common PLC’S.
The standard modeles offer 9, 15, 25, 37 and 50 connections either in male or female
connector type to fit different application. Customer specified design will be accepted
for particular requirement. The modules can be mounted on standard mounting rails
TS15, TS32 and TS35.
ORDER GUIDE
No of Poles
Dimensions L x W x H (mm)
P_PL_oUG_le MOD - 0_C9 -_oM_nnector09_Type
MOD - 15 - M
15
9P MOD - 25 - M Male25
Dimension46(xL85×xW52 × H)
68 x 58 x 52
46 ×982 5x 8×5 x5522
MOD - 37 - M
37
122 x 85 x 52
MOD - 50 - M
50
Dimensio1n5s7 x: 8M5 xil5li2metres
SOCKET
MOD - 09 - F
09
MOD - 15 - F
15
MOD - 25 - F
25
MOD - 37 - F
37
MOD - 50 - F
50
46 x 85 x 52
68 x 85 x 52
92 x 85 x 52
122 x 85 x 52
157 x 85 x 52
86 x 85 x53
Part Number Table
Description
D-Sub Module, Plug, 9 Ways
Part Number
MOD-0X9X-M
Important Notice : This data sheet and its contents (the “Information”) belong to the members of the Premier Farnell group of companies (the “Group”) or are licensed to it. No licence is granted
for the use of it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change
without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, any
error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make any
assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or where the
Group was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict the Group’s liability for death or personal injury resulting from its negligence.
Multicomp is the registered trademark of the Group. © Premier Farnell plc 2012.
www.element14.com
www.farnell.com
www.newark.com
Page <1>
27/09/12 V1.0