|
MH-1 Datasheet, PDF (1/1 Pages) List of Unclassifed Manufacturers – MicroAmp MH-1 Housing For Single MB Circuit Boards | |||
|
MicroAmp MH-1 Housing
For Single MB Circuit Boards
FEATURES
⢠Rapid prototyping
of 2-port circuits
⢠Compatible with all
MB series boards
⢠SMA female connectors
⢠Ground terminal and
bias feed-through
⢠Cover and mounting
hardware provided
The MicroAmp MH-1 housing will accommodate a single MB series circuit board to create a completely shielded 2-port circuit. Boards are
available for microwave ampliï¬ers, ï¬lters, log detectors, frequency multipliers, dividers, and operational ampliï¬ers. After assembling the
desired MB circuit board, simply drop the board into the housing cavity and screw the board in place using the supplied #1-72 socket head
cap screws. Then insert the SMA connectors into the side walls and secure them with the supplied #2-56 mounting screws and solder the
center pins to the circuit board pads. The ground turret terminal and bias feed-through are then installed into the housing side wall and the
bias connection is soldered in place from the circuit board to the feed-through pin using a small gauge wire. A cover attaches to the top of
the housing with #2-56 screws to complete the shielded assembly. The ï¬nished housing can be mounted to a baseplate using the corner
through holes.
1. Select Circuit Board
2. Assemble Board
OUTLINE DRAWING
3. Install into Housing
4. Add Connectors and Bias
MH-1 KIT CONTENTS
1 ea. Housing
1 ea. Cover
2 ea. SMA female connectors
1 ea. Feed-through bias pin
1 ea. Ground turret terminal
6 ea. #2-56 x 3/16" pan head screws
6 ea. #1-72 x 1/8" socket head cap screws
For additional product information, please visit www.twinind.com
Contact information: 925-866-8946 (phone) 925-866-8937 (fax) Sales@twinind.com
|