KVR21SE15S8-4 Datasheet, PDF (1/2 Pages) List of Unclassifed Manufacturers – 4GB 1Rx8 512M x 72-Bit PC4-2133

Memory Module Specifications
KVR21SE15S8/4
4GB 1Rx8 512M x 72-Bit PC4-2133
CL15 260-Pin ECC SODIMM
DESCRIPTION
This document describes ValueRAM's 512M x 72-bit (4GB)
DDR4-2133 CL15 SDRAM (Synchronous DRAM), 1Rx8, ECC,
memory module, based on nine 512M x 8-bit FBGA
components. The SPD is programmed to JEDEC standard
latency DDR4-2133 timing of 15-15-15 at 1.2V. This 260-pin
SODIMM uses gold contact fingers. The electrical and
mechanical specifications are as follows:
FEATURES
• Power Supply: VDD=1.2V Typical
• VDDQ = 1.2V Typical
• VPP - 2.5V Typical
• VDDSPD=2.2V to 3.6V
• Nominal and dynamic on-die termination (ODT) for
data, strobe, and mask signals
• Low-power auto self refresh (LPASR)
• Data bus inversion (DBI) for data bus
• On-die VREFDQ generation and calibration
• Single-rank
• On-board I2 serial presence-detect (SPD) EEPROM
• 16 internal banks; 4 groups of 4 banks each
• Fixed burst chop (BC) of 4 and burst length (BL) of 8
via the mode register set (MRS)
• Selectable BC4 or BL8 on-the-fly (OTF)
• Fly-by topology
• Terminated control command and address bus
• PCB: Height 1.18” (30.00mm)
SPECIFICATIONS
CL(IDD)
Row Cycle Time (tRCmin)
Refresh to Active/Refresh
Command Time (tRFCmin)
Row Active Time (tRASmin)
Maximum Operating Power
UL Rating
Operating Temperature
Storage Temperature
15 cycles
46.5ns(min.)
260ns(min.)
33ns(min.)
TBD W*
94 V - 0
0^o C to +85^o C
-55^o C to +100^o C
*Power will vary depending on the SDRAM used.
kingston.com
Continued >>
Document No. VALUERAM1474-001.A00 07/21/15 Page 1