|
KVR18R13S8K4-16 Datasheet, PDF (1/2 Pages) List of Unclassifed Manufacturers – 16GB (4GB 1RX8 512M x 72-Bit x 4 pcs.) PC3-14900 | |||
|
Memory Module Speciï¬cations
KVR18R13S8K4/16
16GB (4GB 1RX8 512M x 72-Bit x 4 pcs.) PC3-14900
CL13 Registered w/Parity 240-Pin DIMM Kit
DESCRIPTION
ValueRAMâs KVR18R13S8K4/16 is a kit of four 512M x 72-bit
(4GB) DDR3-1866 CL13 SDRAM (Synchronous DRAM),
registered w/ parity, 1Rx8, ECC, memory modules, based on
nine 512M x 8-bit FBGA components per module. Total kit
capacity is 16GB. The SPDs are programed to JEDEC standard
latency DDR3-1866 13-13-13 at 1.5V. Each 240-pin DIMM uses
gold contact fingers. The JEDEC standard electrical and
mechanical specifications are as follows:
FEATURES
⢠JEDEC standard 1.5V (1.425V ~ 1.575V) Power Supply
⢠VDDQ = 1.5V (1.425V ~ 1.575V)
⢠933MHz fCK for 1866Mb/sec/pin
⢠8 independent internal banks
⢠Programmable CAS latency: 13, 11, 10, 9, 8, 7, 6
⢠Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
⢠8-bit pre-fetch
⢠Burst Length: 8 (interleave without any limit, sequential with
starting address â000â only), 4 with tCCD = 4 which does not
allow seamless read or write (either on the fly using A12 or
MRS)
⢠Bi-directional Differential Data Strobe
⢠Internal (self) calibration: Internal self calibration through ZQ
pin (RZQ: 240 ohm ± 1%)
⢠On Die Termination using ODT pin
⢠On-DIMM thermal sensor (Grade B)
⢠Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE < 95°Cº
⢠Asynchronous Reset
⢠PCB: Height 1.180â (30.00mm), double sided component
kingston.com
SPECIFICATIONS
CL(IDD)
Row Cycle Time (tRCmin)
Refresh to Active/Refresh
Command Time (tRFCmin)
Row Active Time (tRASmin)
Maximum Operating Power
UL Rating
Operating Temperature
Storage Temperature
13 cycles
47.125ns(min.)
260ns(min.)
34ns(min.)
3.373 W* (per module)
94 V - 0
0o C to +85o C
-55o C to +100o C
*Power will vary depending on the SDRAM and
Register/PLL Used.
Continued >>
Document No. VALUERAM1442-001.B00 10/14/14 Page 1
|
▷ |