KVR18L13Q4-32 Datasheet, PDF (1/3 Pages) List of Unclassifed Manufacturers – 32GB 4Rx4 4G x 72-Bit PC3-14900

Memory Module Specifications
KVR18L13Q4/32
32GB 4Rx4 4G x 72-Bit PC3-14900
CL13 Load Reduced DIMM
DESCRIPTION
ValueRAM’s KVR18L13Q4/32 4G x 72-bit (32GB) DDR3-1866
CL13 SDRAM (Synchronous DRAM), 4Rx4, load reduced, ECC
memory module, based on thirty-six DDP 2G x 4-bit
components. The SPD is programmed to JEDEC standard
latency DDR3-1866 timing of 13-13-13 at 1.5V. This 240-pin
LRDIMM uses gold contact fingers. The electrical and
mechanical specifications are as follows:
FEATURES
• JEDEC standard 1.5V (1.425V ~ 1.575V) Power Supply
• VDDQ = 1.5V (1.425V ~ 1.575V)
• 933MHz fCK for 1866Mb/sec/pin
• 8 independent internal banks
• Programmable CAS latency: 13, 11, 10, 9, 8, 7, 6
• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
• 8-bit pre-fetch
• Burst Length: 8 (interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write (either on the fly using A12 or
MRS)
• Bi-directional Differential Data Strobe
• Internal (self) calibration: Internal self calibration through ZQ
pin (RZQ: 240 ohm ± 1%)
• On Die Termination using ODT pin
• On-DIMM thermal sensor (Grade B)
• Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE < 95°Cº
• Asynchronous Reset
• PCB: Height 1.195” (30.35mm), double sided component
SPECIFICATIONS
CL(IDD)
Row Cycle Time (tRCmin)
Refresh to Active/Refresh
Command Time (tRFCmin)
Row Active Time (tRASmin)
Maximum Operating Power
UL Rating
Operating Temperature
Storage Temperature
13 cycles
47.91ns(min.)
260ns(min.)
34ns(min.)
11.070 W*
94 V - 0
0^o C to +85^o C
-55^o C to +100^o C
*Power will vary depending on the SDRAM and
Register/PLL used.
kingston.com
Continued >>
Document No. VALUERAM1444-001.A00 07/02/14 Page 1