K3001 Datasheet, PDF (1/1 Pages) List of Unclassifed Manufacturers – Soft, round, 6mm dia, Hard, flat, 12mm wide, Hard, flat, 25mm wide

Product Information
No: PIS 071
Page 1 of 1 Issue No 5
Date : 03 April 2002 Approved by:
CONDUCTIVE BRUSHES
Code K30..
Vermason
Code
K3001
K3003
K3005
K3007
K3040
K3050
K3051
Description
Soft, round, 6mm dia
Hard, flat, 12mm wide
Hard, flat, 25mm wide
Hard, flat, 50mm wide
Hard, block, 35 x 75mm
Soft, flat, 100mm wide
Soft, flat, 150mm wide
FEC
Code
3547863
265070
518475
3547851
168660
265081
3547875
Introduction:
Conventional brushes with synthetic bristles can generate high charges in use. They are
therefore unsuitable for cleaning ESD sensitive assemblies. Nonetheless it is necessary to
remove solder flux and other dirt particularly in SMD assembly where there are high densities
of components.
A range of conductive brushes allows thorough cleaning without the risk of generating static
charges.
Description:
The brushes consist of a conductive plastic handle and Thunderon conductive fibres, mixed
with animal hair if stiffness is desired. Resistance from the tip of the brush to the handle is less
than 5 x 10⁶ ohm. Brushes should be used by operators who are earthed so as to dissipate any
triboelectrical charges.
Hard brushes are for scrubbing whilst soft ones are for brushing of delicate items such as optics
and diskettes.
The brushes may also be used by an earthed operator to remove a surface charge on a non-
conductor by slowly moving the brush across the surface about 2 - 5 mm above it.
For further information, please contact
Vermason Ltd, 1 Avenue One, Letchworth, Hertfordshire SG6 2HB. UK
Tel: [phone] Fax: [phone]
e-mail : [e-mail]
www.vermason.co.uk