|
HX424S14IBK2-8 Datasheet, PDF (1/2 Pages) List of Unclassifed Manufacturers – DDR4-2400 CL14 260-Pin SODIMM Kit | |||
|
Memory Module Specifications
HX424S14IBK2/8
8GB (4GB 512M x 64-Bit x 2 pcs.)
DDR4-2400 CL14 260-Pin SODIMM Kit
SPECIFICATIONS
CL(IDD)
Row Cycle Time (tRCmin)
Refresh to Active/Refresh
Command Time (tRFCmin)
14 cycles
46.75ns (min.)
260ns (min.)
Row Active Time (tRASmin)
Maximum Operating Power
UL Rating
Operating Temperature
Storage Temperature
29.125ns (min.)
TBD W*
94 V - 0
0°C to 85°C
-55°C to +100°C
*Power will vary depending on the SDRAM used.
DESCRIPTION
FEATURES
HyperX HX424S14IBK2/8 is a kit of two 512M x 64-bit (4GB)
DDR4-2400 CL14 SDRAM (Synchronous DRAM) 1Rx8, memory
modules, based on eight 512M x 8-bit DDR4 FBGA components.
Total kit capacity is 8GB. Each module supports Intel® Extreme
Memory Profiles (Intel® XMP) 2.0. This module has been tested
to run at DDR4-2400 at a low latency timing of 14-14-14 at 1.2V.
Additional timing parameters are shown in the PnP Timing
Parameters section below. The JEDEC standard electrical and
mechanical specifications are as follows:
⢠Power Supply: VDD = 1.2V Typical
⢠VDDQ = 1.2V Typical
⢠VPP - 2.5V Typical
⢠VDDSPD = 2.25V to 3.6V
⢠On-Die termination (ODT)
⢠16 internal banks; 4 groups of 4 banks each
⢠Bi-Directional Differential Data Strobe
⢠8 bit pre-fetch
Note: The PnP feature offers a range of speed and timing options to support
the widest variety of processors and chipsets. Your maximum speed will
be determined by your BIOS.
⢠Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop)
⢠Height 1.18â (30.00mm)
PnP JEDEC TIMING PARAMETERS:
⢠JEDEC/PnP:
⢠XMP Profile #1:
DDR4-2400 CL14-14-14 @1.2V
DDR4-2133 CL13-13-13 @1.2V
DDR4-2400 CL14-14-14 @1.2V
hyperxgaming.com
Continued >>
Document No. 4807391-001.A00 08/25/15 Page 1
|
▷ |