English
Language : 

HX318LC11FB-8 Datasheet, PDF (1/2 Pages) List of Unclassifed Manufacturers – DDR3L-1866 CL11 240-Pin DIMM
Memory Module Specifications
HX318LC11FB/8
8GB 1G x 64-Bit
DDR3L-1866 CL11 240-Pin DIMM
SPECIFICATIONS
CL(IDD)
10 cycles
Row Cycle Time (tRCmin)
Refresh to Active/Refresh
Command Time (tRFCmin)
44.75ns (min.)
260ns (min.)
Row Active Time (tRASmin)
32.125ns (min.)
Maximum Operating Power
UL Rating
Operating Temperature
Storage Temperature
TBD W*
94 V - 0
0o C to 85o C
-55o C to +100o C
*Power will vary depending on the SDRAM used.
DESCRIPTION
FEATURES
HyperX HX318LC11FB/8 is a 1G x 64-bit (8GB) DDR3L-1866
CL11 SDRAM (Synchronous DRAM) 2Rx8, low voltage, memory
module, based on sixteen 512M x 8-bit DDR3 FBGA compo-
nents. Each module kit supports Intel® Extreme Memory
Profiles (Intel® XMP) 2.0. This module has been tested to run
at DDR3L-1866 at a low latency timing of 11-11-11 at 1.35V.
Additional timing parameters are shown in the PnP Timing
Parameters section below. The JEDEC standard electrical and
mechanical specifications areas follows:
Note: The PnP feature offers a range of speed and timing options to support
the widest variety of processors and chipsets. Your maximum speed will
be determined by your BIOS.
PnP JEDEC TIMING PARAMETERS:
• JEDEC/PnP:
• XMP Profile #1:
DDR3L-1866 CL11-11-11 @1.35V/1.5V
DDR3L-1600 CL10-10-10 @1.35V/1.5V
DDR3L-1333 CL8-8-8 @1.35V/1.5V
DDR3L-1866 CL11-11-11 @1.35V
• JEDEC standard 1.35V and 1.5V Power Supply
• VDDQ = 1.35V and 1.5V
• 933MHz fCK for 1866Mb/sec/pin
• 8 independent internal bank
• Programmable CAS Latency: 13, 11, 10, 9, 8, 7, 6
• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
• 8-bit pre-fetch
• Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
MRS]
• Bi-directional Differential Data Strobe
• Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
• On Die Termination using ODT pin
• Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE ≤ 95°C
• Asynchronous Reset
• Height 1.291” (32.80mm) w/heatsink, single sided
component
hyperxgaming.com
Continued >>
Document No. 4807385-001.A00 08/24/15 Page 1