HSL-HUB3 Datasheet, PDF (1/1 Pages) List of Unclassifed Manufacturers – High Speed Link Extension Modules

HSL-HUB3 / HSL-Repeater
High Speed Link Extension Modules
HSL Slave Modules
1
Software &
Utilities
2
DAQ
HSL-HUB3
HSL-Repeater
Features
■ Linking style: Master to HUB, HUB to HUB, HUB to Slave
■ Support T bracing connection and star connection (subsystem concept)
■ One input port with 3 output segment ports
■ Jumper selectable transmission speeds: 3/6/12 Mbps
■ Full and half duplex transmission mode are jumper selectable
■ RJ-45 phone jack for easy installation
■ 24 VDC input
The extension possibility of HSL system by using
HSL-HUB3/HSL-Repeater
Without HSL-Repeater
300 m
General Introduction
The HSL-HUB3 is an HSL subsystem which can offer one to three port
transformation in automation applications. Unlike the traditional daisy
chain configurations, the HSL-HUB3 provides more flexible connections
(tree configurations) while building up the application.
The HSL-Repeater is the HSL subsystem which can extend the connection
distance in automation application, especially in factory automations.
One HSL bus can connect up to seven repeater modules and wire
lengths up to 2.4 KM at a 3 Mbps transmission rate. In other words, all
2016 points can be monitored within 4 ms via the HSL bus up to 2.4 KM
in length to provide fast, time-deterministic, and robust configurations
over traditional RS-485 devices.
With HSL-Repeater
X8
2400 m
Without Repeater Repeater X 1 Repeater X 2 Repeater X 5 Repeater X 7
12 Mbps
6 Mbps
3 Mbps
100 m
200 m
300 m
200 m
400 m
600 m
300 m
600 m
900 m
600 m
1200 m
1800 m
800 m
1600 m
2400 m
HSL-Terminator
High Speed Link Extension Module
Features
■ Linking style: Master to HUB, HUB to HUB, HUB to Slave
■ Support T bracing connection and star connection (subsystem concept)
■ One input port with 3 output segment ports
■ Jumper selectable transmission speeds: 3/6/12 Mbps
■ Full and half duplex transmission mode are jumper selectable
■ RJ-45 phone jack for easy installation
■ 24 VDC input
3
PXI
4
Modular
Instruments
5
GPIB & Bus
Expansion
6
Motion
Control
7
Real-time
Distributed
I/O
8
PAC
9
Remote I/O
10
Communi-
cations
11
Vision
General Introduction
The HSL-Terminator can be used for stable communication. The HSL-
Terminator provides an adjustable resistor to allow the impedance of the
wiring of the HSL system or Motionnet system to be adjusted to ensure
the quality of the transmission.
12
Fanless
Embedded
Computers
13
cPCI &
Industrial
Computers
www.adlinktech.com ^7-10