FN2200-600-99 Datasheet, PDF (1/4 Pages) List of Unclassifed Manufacturers – DC EMC/EMI Filter for PV Inverters

EMC and Power Quality 
DC EMC/EMI Filter for PV Inverters
DC Filters
FN 2200
Technical specifications
Maximum continuous operating voltage:
Operating frequency:
Rated currents:
High potential test voltage:
Protection category:
Overload capability:
Temperature range (operation and storage):
Flammability corresponding to:
Design corresponding to:
MTBF @ 55°C/1200 V (Mil-HB-217F):
I Reduces conducted emissions towards
the solar panel
I Reduces the probability of EMI radiation
off the solar panel
I Helps to prevent pre-mature panel aging
because of HF leakage currents
I Helps to meet international EMC
regulations for the entire PV system
I Most compact standard solution in the
industry, optionally available without
capacitors to ground (B types)
Approvals
(600VDC)
(850VDC)
Max. 1200 VDC
DC
25 to 2300 A @ 55°C
P –> E 3600 VDC for 5 sec
P –> P 3000 VDC for 5 sec
IP20 (25 to 150 A types); IP00 (250 to 2300 A types)
4× rated current at switch on,
1.5× rated current for 1 minute, once per hour
-40°C to +100°C (40/100/21)
UL 94V-2 or better
UL 1283, CSA 22.2 No. 8 1986, IEC/EN 60939
min. 223,000 hours
Typical electrical schematic
Cx R
L
Cy
Cx R
R
Features and benefits
FN 2200 range of standard EMC/EMI filters FN 2200 are the most compact dedicated DC
is based on Schaffner’s years of experience in filters for PV inverters in the industry and
custom filter design for the global photovoltaic therefore support the integration in the ever
(PV) inverter industry. Installed between the shrinking frame sizes of today’s power elec-
PV inverter and the solar panel, FN 2200 DC tronics. All FN 2200 come in unsymmetrical
filters help to control conducted emissions
housings, which help to prevent inverse
on the panel side of the system and therefore installation and wrong electrical connection.
significantly reduce the potential for high-
Along with grid-side installed Schaffner AC
frequency (HF) interference radiation off
EMC/EMI filters, FN 2200 are key to meet
the panel. The filter also protects the solar
the stringent international standards for
panel from HF stray and leakage currents
electromagnetic compatibility (EMC) like EN
which can cause pre-mature aging in the PV 61000-6-3 and -6-4 and help to ensure a reli-
modules.
able and fault-free operation of the entire PV
system.
FN 2200 are designed for very low power
loss, to support overall PV system efficiency.
Typical applications
FN 2200 are primarily designed for PV invert-
ers. However, they can potentially also be
used in other DC applications within pub-
lished specifications, like UPS, DC motor
drives, or DC quick chargers.