FH21-8S-1DSA Datasheet, PDF (1/4 Pages) List of Unclassifed Manufacturers – 1mm Pitch FPC/FFC Connector

The product information in this catalog is for reference only. Please request the Engineering Drawing for the most current and accurate design information.
All non-RoHS products have been discontinued, or will be discontinued soon. Please check the products status on the Hirose website RoHS search at www.hirose-connectors.com, or contact your Hirose sales representative.
1mm Pitch FPC/FFC Connector
FH 21 Series
sFeatures
1. LIF (Low Insertion Force) Mechanism
LIF mechanism secures mounting serviceability.
2. Kink Mechanism
DIP post is treated with kinks, and prevent connector
floating in the soldering process.
3. Contact Structure on Both Sides
The contact structure on both sides does restrict
directionality of FPC and FFC conductors.
sApplications
HDD, facsimiles, printers, and crystal liquie modules, etc.
sProduct Specifications
Rating
Rated Current: 0.5A Operating Temperature Range: -30 ~ ⁺⁷⁰ç (Note 1) Storage Temperature Range: -10 ~ ⁺⁵⁰ç (Note 2)
Rated Voltage: 50V AC Operating Humidity Range: Relative humidity 90% max. Storage Humidity Range: Relative Humidity: 90% max.
(Not dewed)
(Not dewed)
Applicable FPC
t=0.3±0.05 Solder plating
Item
Specification
Condition
1. Insulation Resistance 500Mø min.
Measured at 100V DC
2. Withstand voltage
Neither short nor breakdown should occur
150V AC for 1 minute
3. Contact Resistance
40mø
*FPC conductor resistance included
Measured at 100mA
Contact resistance: 40mø max.
4. Mechanical Operation
No part should be damaged, cracked, or loosened
10 cycles
Electrical discontinuity, 1µS max.
Frequency 10~55Hz and single amplitude 0.75mm in
5. Vibration
Contact resistance: 40mø
3 directions for 2 hours, respectively.
No part should be damaged, cracked, or loosened
6. Shock
Electrical discontinuity, 1µS max.
Contact resistance: 40mø max.
No part should be damaged, cracked, or loosened
Acceleration: 490m/s, duration: 11ms, sine half-wave
in 3 directions for 3 cycles, respectively
7. Moisture Resistance
7. in Steady State
Contact resistance: 40mø max.
Insulation resistance: 50Mø max.
No part should be damaged, cracked, or loosened
Exposed to temperature 60ç and humidity 90~95%
for 96 hours
Note 1. Temperature rise included when energized
Note 2. This storage indicates a long-term storage state for the unused product before the board mounted.
Note 2. The operating temperature and humidity ranges are applied to the non-energized state after the connector has been
installed in the board.
Note 3. The above standards represent this series. The individual formal agreement should be based on the "Specification".
D15