CPCI-6210 Datasheet, PDF (1/2 Pages) List of Unclassifed Manufacturers – Remote management support

cPCI-6210 Series
6U CompactPCI^® Quad-Core 2nd Generation
Intel^® Core™ i7 Processor Host/Peripheral Blade
Features
Quad-core Intel^® Core™ i7-2710QE
KB/MS
processor @2.1GHz
DP
PMC/
XMC
DisplayPort, DVI and VGA graphics
interfaces
DVI-I
SATA 6 Gb/s and CFast storage interfaces
PCI Express x8 XMC slot in 8HP version
LAN
COM _{Remote management support}
USB
COM
2
cPCI-6210
cPCI-6210D
CompactPCI ^R
Specifications
Processor & System
CPU
Chipset
Memory
BIOS
CompactPCI Bus
PICMG Standards
uFC-PGA Intel^® Core™ i7-2710QE Processor 2.1GHz
(Turbo boost to 3GHz), 6MB LLC, 45W TDP (4C)
uFC-PGA Intel^® Core™ i5-2510E Processor 2.5GHz
(Turbo boost to 3.2GHz), 3MB LLC, 35W TDP (2C)
uFC-PGA Intel^® Celeron^® B810 Processor 1.6GHz,
2MB LLC, 35W TDP (2C)
Supports Intel^® Hyper-Threading and Turbo Boost
Technology for Core™ i5/i7 processors
Intel^® QM67 PCH
Dual channel DDR3-1066/1333/1600 SDRAM via two
SODIMM sockets, up to 16GB capacity (dependent on
available memory modules)
AMI^® EFI BIOS, 64Mbit SPI flash memory
PCI 64bit/ 66MHz, 3.3V or 5V universal V(I/O)
Supports operation in system slot as master or in
peripheral slot as stand-alone blade without connectivity to
CompactPCI^® bus (Satellite mode)
PICMG 2.0 CompactPCI R3.0
PICMG 2.1 Hot Swap R2.0
PICMG 2.9 System Management R1.0
PICMG 2.16 Packet Switch Backplane R1.0
Connectivity
PMC/XMC
Ethernet
Graphics
USB
PS/2
Serial Port
Audio
One PCI 32bit, 33/66MHz PMC or PCIe x8 XMC site (8HP only)
Three PCI Express Intel^® 82574L GbE and one Intel^®
82579LM PHY controllers for four 10/100/1000BASE-T ports
Three RJ-45 ports on front panel; two to J3 for PICMG 2.16
(one switched from front panel)
Supports KVM Redirection and SOL
Integrated in Intel^® Core™ processor, 3D engine
One DVI-I (digital+analog) port on front panel, analog RGB is
switchable to rear, supports up to QXGA 2048x1536 pixels
@75Hz, 32bits
One dual mode DisplayPort on front panel, supports up to
2560×1600 pixels @60Hz; DVI, VGA and HDMI interfaces are
available by adapter cables
One DVI port routed to rear
Additional discrete ATI/AMD E4690 GPU supporting two
DVI-I ports on RTM cPCI-R6700
Up to four independent displays
Up to three USB 2.0 front panel ports
Six USB ports routed to rear
Front panel PS/2 keyboard mouse port
Up to two serial ports on front panel (1 for 4HP, 2 for 8HP)
Supports RS-232/422/485 on COM1
Additional two serial ports routed to rear
High Definition Audio signals routed to rear
2-11
http://www.adlinktech.com/cPCI/
Storage
SBC
RTM
One SATA 6 Gb/s direct connector for 2.5” onboard HDD/SSD
One SATA 6 Gb/s signal connector (7-pin) on board
Onboard CFast socket on SATA 3 Gb/s
Up to 3 SATA ports
CF (x1) and SD (x1) sockets
Eight SAS ports by LSISAS1068E with hardware RAID by two
mini SAS x4 connectors
Operating System
OS
Microsoft Windows^® XP
Microsoft Windows^® 7
RedHat Enterprise Linux 6
Fedora 14
Wind River VxWorks 6.9, 6.8, 5.4
(Please contact ADLINK for other OS support)
Miscellaneous
LED
Power, WDT, Hard Disk, Hot Swap
Battery
Coin cell lithium battery onboard for RTC CMOS RAM
TPM
Atmel AT97SC3204 (optional, support upon request)
Watchdog Timer
System Reset and NMI, with programmable interval, 1-65535
seconds or minutes
Hardware Monitor
Monitors CPU temperature, system temperature, Vcore and
DC voltages
Mechanical & Environmental
Form Factor
6U 4HP/8HP CompactPCI^®
233.33mm x 160mm (LxW)
Equipped with CompactPCI connectors J1, J2, J3, J5
Operating Temperature 0°C to 60°C
-40°C to 70°C extended temperature (cPCI-ET6210 models)
-40°C to +85°C extreme extended temperature (CPUs with
35W TDP, 8HP only)
Storage Temperature -40°C to 85°C
RH Humidity
95% non-condensing
Shock
15G peak-to-peak, 11ms duration, non-operating
Vibration
2 Grms random vibration, 5-500Hz, each axis
Power Consumption* 1.35A@3.3V, 7.9A@5V, total 44W for Core i5-2510E
1.36A@3.3V, 13.56A@5V, total 72.3W for Core i7-2710QE
*100% CPU loading under Windows XP with Turbo Boost
and Hyper-Threading enabled
EMI/EMC
EN 55022 Class A, EN 55024, EN 61000-3-2, EN 61000-3-3