CONMMCX012-R178 Datasheet, PDF (1/1 Pages) List of Unclassifed Manufacturers – MMCX MALE RIGHT ANGLE CABLE END CRIMP FOR RG178 CABLE

Description
Body
Pin
Insulation
Snaps
Crimp Ring
Insulator
Cover
Heat Shrink
Material
Brass
Brass
Teflon
BE CU
Brass
Teflon
Brass
Polyolefin
Finish
Gold
Gold
Teflon
Gold
Gold
Gold
Nickel
Black
SIDE VIEW
0.104
(2.65)
0.270
(6.85)
0.138
(3.50)
Ø0.093
(2.35)
REVISIONS
REV
DESCRIPTION
INSULATOR
COVER
DATE APPV
0.354
(9.00)
Assembly Instructions
1. Strip coax as shown. Put heat shrink,
then crimp ring onto cable.
2. Slide the coax into the body until the
center conductor is centered in the fork.
3. Push the shield over the barrel.
4. Solder the center conductor into
center of the fork.
5. Slide the crimp ring over the shield and
crimp with a 0.100” crimp die.
6. Trim off any excess shield wire sticking
out from the ring.
7. Slip the heat shrink tube over the crimp ring
until it is against the body and then heat shrink.
8. Slip insulator into body.
9. Push cover into the opening.
RECOMMENDED CABLE STRIPPING DIMENSIONS
0.028
(0.70)
0.059
(1.50)
0.217
(5.50)
RG-178 Cable
BRAIDED SHIELD
0.197
(5.00)
BARREL
Ø0.079
(2.00)
CRIMP RING
0.276
(7.00)
Ø0.126
(3.20)
HEAT SHRINK
Ø0.118
(3.00)
0.787
(20.00)
NOTES: (UNLESS OTHERWISE SPECIFIED)
1. ALL DIMENSIONS ARE IN INCHES [mm].
2. DIMENSIONS APPLY AFTER FINISHING.
3. MANUFACTURE TO BE COMPLIANT WITH EU RoHS DIRECTIVE.
4. SAFETY BREAK ALL SHARP CORNERS AND EDGES .02 MAXIMUM.
WARNING : THIS DRAWING CONTAINS PROPRIETARY INFORMATION
THAT IS THE SOLE PROPERTY OF CONNECTOR CITY, AND SHALL BE
TREATED AS SUCH. NO DISCLOSURE OR REPRODUCTION OF THIS
159 ORT LANE
MERLIN, OR 97532
DOCUMENT IS PERMITTED, IN WHOLE OR IN PART, WITHOUT THE _TITLE:
EXPRESS WRITTEN PERMISSION OF CONNECTOR CITY OR ITS
DESIGNATED AGENTS.
MMCX MALE RIGHT ANGLE
MATERIAL:
TOLERANCES:
PROJECTION: _{CABLE END CRIMP FOR RG178 CABLE}
.020 [0.50]-.200 [5.00]= .008 [0.20]
FINISH:
.200 [5.00]-1.200 [30.00]= .016 [0.40]
1.20 [30.0]-4.75 [120.0]= .024 [0.60]
SIZE DWG. NO.
REV
4.75 [120.0]-12.40 [315.0]= .040 [1.0] ^{ANGLES: 1}
DRAWN: CJ
DT: 7/27/09
A
CONMMCX012-R178
B
ENGR:
DT:
SCALE: 2:1
DO NOT SCALE DRAWING
SHEET 1 OF 1
LDCFDCC_A