COM-1240 Datasheet, PDF (1/2 Pages) List of Unclassifed Manufacturers – MVB Interface Board

COMMUNICATION MODULES
COM-1240 MVB Interface Board
Architecture:
MVB Devices Class:
Device interface:
Internal CPU:
SRAM:
Dimensions (L x W x H):
Power supply:
Power consumption:
Operating temp. range:
Relative Humidity:
Supported O. S.:
PC/104 compliant
3 (4 optional)
EMD (Electrical Middle Distance)
32 bits, 24 MHz RISC processor
1 MB (accessible from host)
90mm x 96mm x 15mm
+5 Volts ± 5%
3.5 Watts
-25°C to +85°C (EN50155 compliant)
95% max
(non condensing)
Linux, WinCE
DATA SHEET
Main Features
RoHS
General Description
The COM-1240 is an MVB interface board, compliant with the 2002/95/CE (RoHS) directive, specifically developed to be used as a
gateway between a PC104 system and the MVB bus (Multifunctional Vehicle Bus, as used in rail applications).
It will allow for enhanced communications with the devices installed on board railway vehicles thus simplifying connections and
widening compatibility.
The COM-1240 features the 32 bit, 24 MHz RISC microprocessor and supports the complete TCN (Train Communication Network)
protocol stack Class 3 (optionally Class 4), up to the session layer. This will free up resource requirements on the main CPU
Module, as it will only need to handle the application layer of the TCN protocol.
The COM-1240 is lightweight and has very low power consumption. It is EN50155 compliant, so it will be resistant to high
vibrations, humidity and temperature extremes.
Tel. [phone]
Fax. [phone]
E-mail: [e-mail]
URL: www.eurotech.it
Note: The information in this document is subject to change without notice and should not be construed as a commitment by EuroTecH S.p.A.
While reasonable precautions have been taken, EuroTecH S.p.A. assumes no responsibility for any error that may appear in this document.
All trademarks or registred trademarks are the properties of their respective companies.
ETH_COM-1240_DS180708