ANT-916-WRT-XXX Datasheet, PDF (1/1 Pages) List of Unclassifed Manufacturers – Adhesive or permanent mount

™
ANT-916-WRT-xxx DATA SHEET
Product Dimensions
0.43”
(11.0)
0.24”
(6.0)
0.75”
(19.0)
Adhesive Ring
Remove protective plastic
before installation
M11x1.0mm
Thread
3.25”
(82.5)
0.207”
(5.26)
Description
The WRT Series antenna is ideally suited for
applications such as wireless vending, security,
traffic, or power equipment which require an
unobtrusive, tamper-resistant antenna solution.
The tiny 19 x 11mm radome installs through a
small hole on the product and is anchored by a
threaded base. An adhesive foam compression
ring is used to resist the elements. The 1/4-wave
antenna also features an integral counterpoise,
which eliminates the need for a proximity
ground plane. The antenna's coax feed is available with SMA or
RP-SMA terminations. Alternate coax lengths, connectors and
custom colors are available for volume OEM customers.
Features
· Low cost
· Unobtrusive
· Tamper resistant
· Integral counterpoise
· Indoor / outdoor
· Adhesive or permanent mount
Electrical Specifications
· Center Freq.
916MHz
· Recommended Oper. Freq.
900-930MHz
· Wavelength
1/4-wave
· VSWR
<1.9 typ. at center
· Impedance
50 ohms
· Connector
RP-SMA or SMA
Electrical specifications and plots measured on 24” x 24” reference ground plane
Ordering Information
· ANT-916-WRT-RPS (with RP-SMA connector)
· ANT-916-WRT-SMA (with SMA connector)
RG-174 Cable Length
8.50”
(216.0)
VSWR Graph
S11 SWR
1.753
CENTER 916.000MHz
SPAN 200.000MHz
Typical VSWR
Antenna Factor 159 Ort Lane Merlin, OR 97532 www.antennafactor.com
541-956-0931 (phone) 541-471-6251 (fax)
Rev 5-24-10