|
ANT-2.4-PW-QW Datasheet, PDF (1/1 Pages) List of Unclassifed Manufacturers – Use with plastic or metal enclosures | |||
|
Product Dimensions
0.53â
(13.5)
4.13â
(105.0)
0.31â
(7.8)
1/4-28
UNF
7/16â
HEX
0.20â
(5.0)
0.57â
(14.5)
End View
ANT-2.4-PW-QW DATA SHEET
Description
Designed for permanent attachment, PW Series 1/2-
wave whips give outstanding performance in a rugged
and cost-effective package. The antenna is attached by
placing its base through a 1/4â hole in the product and
securing it with a nut or by threading it into a PEM-style
insert. This method of attachment is highly secure and
saves the cost of an antenna connector. The antenna is
fed through the base with RG-174 coax cable, which may
be soldered directly to the board or attached using a 50-
ohm connector. Standard cable length is 8.5â. Custom
lengths and terminations are available by special order.
Features
⢠Low cost
⢠Outstanding performance
⢠Omni-directional pattern
⢠Wide bandwidth
⢠Flexible main shaft
⢠Rugged & weatherized
⢠Integral 8½-inch RG-174 coax cable
⢠Use with plastic or metal enclosures
Electrical Specifications
⢠Center Freq.
⢠Bandwidth
⢠Wavelength
⢠VSWR
⢠Impedance
⢠Connection
⢠Cable
2.45GHz
250MHz
1/2-wave
<1.9 typ. at center
50 ohms
Case-mount
8½-inch RG-174 coax
Electrical specifications and plots measured on 4.00â x 4.00â reference ground plane
Ordering Information
⢠ANT-2.4-PW-QW
VSWR Graph
S11 SWR
1.373
CENTER 2450.000MHz
SPAN 200.000MHz
Typical VSWR
Antenna Factor 159 Ort Lane Merlin, OR 97532 www.antennafactor.com
541-956-0931 (phone) 541-471-6251 (fax)
Rev 4-13-09
|