A96020 Datasheet, PDF (1/1 Pages) List of Unclassifed Manufacturers – Voice Recording Module 20” x 2 sections

A96020
Voice Recording Module
20” x 2 sections
Description
The A96020 voice recording module offers true single chip solid state storage capability and requires no software or
micro-controller support. It provides high quality recording and playback with dual 20 second message.
Features
Non volatile flash memory technology
No battery back up required
User friendly, easy to operate
Slide switch for record or play back
Separate key to trigger message 1 or 2
Low power consumption
LED to indicate recording and playback
Built-in condenser mic
Automatic power down
5-6V Operation
Operation
Recording
1. Turn slide Switch to REC position, press M1 or M2 to start recording, release key when recording complete. LED
will light up during recording. If voice message is longer than 20sec, it will beep twice, LED will turn off and stop
recording.
2. If there is a message recorded previously, press REC will erase the previous and record the new one.
Play Back
1. Turn slide switch to PLAY position, press M1, or M2 to start play back. The message will be played back from
the beginning until ended. During play mode, if key PLAY is pressed, the message will stop immediately.
2. If the newly recorded message is shorter than the previously recorded message, the remaining portion of the
previous message will be erased.
Standby
The module will automatically enter standby mode after recording or playback operation is completed.
Connectors and Switches
SPK 0.1” pitch pin connector for speaker
PWR 0.1” pitch pin connector for DC power, note polarity
SEL Slide switch for Record/Playback
M1 Push button for message 1
M2 Push button for message 2
Electrical Spec
Parameter
Typical Max Unit
Operation Voltage
6
6.5
V
Operation Current (8Ω Speaker
connected)
Recording ₄₅
mA
Playback ₇₀
Standby Current
200 250 uA
PCB Layout of the module
Size : 34 x 23 mm
Spk
Mic
GND
+6V
Rec/Play
LED
M1
M2