9801 Datasheet, PDF (1/5 Pages) List of Unclassifed Manufacturers – 0 to 300 V, low distortion AC power source with models delivering a maximum of 1500 VA, 12 Arms / 48 Apeak

Data Sheet
Programmable AC Power Sources
9800 Series
The 9800 Series is both a programmable
AC source and measurement tool. These fully
programmable linear AC sources deliver a
maximum of 1500 VA through the universal line
output terminals on the front and the output
connector on the rear. The output can be varied
from 0 to 300 V with 0.1 V programming
resolution. The output frequency can also be
adjusted from 45 Hz to 500 Hz with start and
stop phase angle from 0 to 360 degrees. The
bright VFD display shows Vrms, Irms, Ipeak,
frequency, power factor (PF), apparent power,
true power, and elapsed output time.
These AC sources provide a power line
disturbance (PLD) simulator, list mode, and
sweep mode for simulation of common power
grid faults and disturbances. A built-in dimmer
function is also available for testing motors and
LEDs.
* 9803 and 9805 models only
List mode can be used to generate sequences of
waveforms such as surges, sags, and frequency
disturbances. The programmed list can be
triggered from the front panel or via BNC
connector on the rear.
Standard USB, RS232, LAN and GPIB*
interfaces can be used to remotely control the
source via a PC. Free application software and
LabVIEW driver are available to reduce
programming time and increase productivity.
Common applications
The 9800 Series AC power sources are suitable
for evaluating transformers, TRIACs, SCRs and
passive components as well as production, R&D,
service, and pre-compliance testing.
Model
Voltage (rms)
Max. Power
9801
300 VA
9803
0 - 300 V
750 VA
9805
1500 VA
Features
I 0 to 300 V, low distortion AC power source
with models delivering a maximum of
1500 VA, 12 Arms / 48 Apeak
I Output frequency adjustable from
45 Hz – 500 Hz
I Select 150 V / 300 V autoranging or 300 V
range operation for continuous sweep from
0 - 300 V
I Displays Vrms, Irms, Ipeak, frequency, PF,
apparent power, true power, and elapsed
output time
I Adjustable phase angle control
I Programmable voltage and frequency limit
settings
I Built-in PLD and dimmer simulation
I Voltage and frequency sweep mode
I List mode: 10 user-defined programs with up
to 100 programmable steps each
I BNC I/O for external triggering, output status
indication/control, and synchronization
I Save and recall up to 100 instrument settings
I Standard USB (USBTMC-compliant),
RS232, LAN and GPIB* interfaces
I OVP/OCP/OPP/OTP protection modes and key
lock function
I Pre-compliance testing for voltage dips and
frequency simulations according to
IEC61000-4-11 / 4-14 / 4-28
I LabVIEW driver and softpanel for remote
control available
Technical data subject to change
© B&K Precision Corp. 2015
www.bkprecision.com