8FSM15S-30N4-FEC Datasheet, PDF (1/2 Pages) List of Unclassifed Manufacturers – Metal D Type IDC Connectors - Unthreaded

PART NO.
8FSM Series
ECN # REV
-
A
REVISIONS
DESCRIPTION
RELEASED
DRAWN DATE CHECKD DATE APPRVD DATE
Ashok 19/01/12 Jagan 19/01/12 Farnell 02/02/12
Recommended Panel Cut-out Dimensions
Dimensions : Millimetres (Inches)
Specifications:
Current rating
Minimum insulation resistance
Minimum dielectric withstanding voltage
Operating temperature
Contact resistance
Dielectric material
Colour
Contact material
Contact plating
Wire size
: 1 ampere
: ≥1,000 MΩ (at 500 V dc)
: 500 V ac (for one minute)
: -55°C to 105°C
: ≤15 mΩ
: PBT with glass-fibre reinforced
: Black, blue and grey (optional)
: Phosphor bronze
: Gold over nickel
: AWG 26 and 28 stranded,
1.27 mm conductor centre flat cable
Important Notice : This data sheet and its contents (the "Information") belong to the mem-
bers of the Premier Farnell group of companies (the "Group") or are licensed to it. No
licence is granted for the use of it other than for information purposes in connection with
the products to which it relates. No licence of any intellectual property rights is granted. The
Information is subject to change without notice and replaces all data sheets previously sup-
plied. The Information supplied is believed to be accurate but the Group assumes no
responsibility for its accuracy or completeness, any error in or omission from it or for any
use made of it. Users of this data sheet should check for themselves the Information and
the suitability of the products for their purpose and not make any assumptions based on
information included or omitted. Liability for loss or damage resulting from any reliance on
the Information or use of it (including liability resulting from negligence or where the Group
was aware of the possibility of such loss or damage arising) is excluded. This will not oper-
ate to limit or restrict the Group's liability for death or personal injury resulting from its negli-
gence. Multicomp is the registered trademark of the Group. © Premier Farnell plc 2012.
TOLERANCES:
UNLESS OTHERWISE
SPECIFIED,
DIMENSIONS ARE
FOR REFERENCE
PURPOSES ONLY.
DRAWN BY:
Ashok
CHECKED BY:
Jagan
APPROVED BY:
DATE:
19/01/12
DATE:
19/01/12
DATE:
02/02/12
DRAWING TITLE:
Metal D Type IDC Connectors - Unthreaded
SIZE DWG NO.
A
M10001972
ELECTRONIC FILE
REV
50302_DWG
A
SCALE: NTS
U.O.M.: mm (Inches)
SHEET: 1 OF 2