760308111 Datasheet, PDF (1/6 Pages) List of Unclassifed Manufacturers – WE-WPCC Wireless Power Charging Transmitter Coil

A Dimensions: [mm]
B Recommended hole pattern: [mm]
C Schematic:
D Electrical Properties:
Properties
Test conditions
Value Unit
Tol.
Inductance
125 kHz/ 10 mA
L
6.3
µH
±10%
Q-factor
125 kHz/ 10 mA
Q
80
typ.
Rated current
Saturation current
DC Resistance
DC Resistance
Self resonant frequency
∆T = 40 K
@ 20°C
@ 20°C
IR
13
A
max.
Isat
16.0
A
typ.
RDC
0.017
Ω
typ.
RDC
0.025
Ω
max.
fres
20
MHz
E General information:
It is recommended that the temperature of the part does
not exceed +105°C under worst case conditions.
•Storage Temperature: -20°C to 60°C
•Operating Temperature: -20°C to 105°C
•Test conditions of Electrical Properties: 20°C, 33% RH
if not specified differently
•Transmitter A11 according to Qi standard
DESCRIPTION
1.9
2014-08-11
SSt
CSo
1.8
2014-06-02
SSt
CSo
1.7
2013-12-18
SSt
SSt
Würth Elektronik eiSos GmbH & Co. KG
1.6
2013-10-30
SSt
CSo
EMC & Inductive Solutions
Max-Eyth-Str. 1
1.5
2013-07-15
SSt
OO
74638 Waldenburg
1.4
2013-04-11
SSt
Germany
SSt
Tel. [phone] - 0
1.3
2013-02-28
SSt
OO
www.we-online.com
[e-mail]
REV
DATE
BY
CHECKED
WE-WPCC Wireless Power Charging
Transmitter Coil
Order.- No.
SIZE
760308111
A4
Size: 5353
This electronic component has been designed and developed for usage in general electronic equipment only. This product is not authorized for use in equipment where a higher safety standard and reliability standard is especially required or where a failure of the product is reasonably expected to cause severe personal injury or death, unless the parties have executed an agreement specifically governing such use.
Moreover Würth Elektronik eiSos GmbH & Co KG products are neither designed nor intended for use in areas such as military, aerospace, aviation, nuclear control, submarine, transportation (automotive control, train control, ship control), transportation signal, disaster prevention, medical, public information network etc.. Würth Elektronik eiSos GmbH & Co KG must be informed about the intent of such usage before
the design-in stage. In addition, sufficient reliability evaluation checks for safety must be performed on every electronic component which is used in electrical circuits that require high safety and reliability functions or performance.