English
Language : 

7500 Datasheet, PDF (1/1 Pages) List of Unclassifed Manufacturers – 229-2 Leakage Current Tester
229-2 Leakage Current Tester
AC Current Leakage Tester
Small leakage currents can be dangerous! The current above the "threshold of
perception" in appliances, motors and other equipment can cause a violent reaction
which may result in serious physical injury. For service, lab, production or industry,
the Model 229-2 helps determine product conformance to standards.
CAUTION! Leakage current in appliances may increase with use and aging. Check
appliances periodically for safety.
• Designed around ANSI C39.5 requirement for the measurement of AC
leakage current and UL Safety Standards.
• Compensated to Approximate Dalziel's Perception Curve
• Overload protected Up to 500 V Peak Momentarily on all ranges
• Checks both 120 VAC and 240 VAC appliances
• Includes Test Leads, Battery and Manual
Specifications
Ranges: AC current: 0.3-1-3-10 mA
AC voltage: 0-150 and 0-300 volts
Battery Test: Replace-Good
Short Test: Red Arc: 30 mA FS, Green arc: 10 mA or less
Resolution: 5␮A on 0.3 mA range
Accuracy: Ϯ3% at 60 Hz
Input Impedance: For current tests, 1.5K⍀ in parallel with 0.15 ␮F
Input Resistance: 0.5 M⍀ for 150V Range, 1.0 M⍀ for the 300V range
Accuracy Vs. Frequency: Approximates Dalziel's "Percentile 50 Threshold of
Perception Curve" within Ϯ1.0 dB
Battery Life: Approximately 200 hours
Rated Circuit to Ground Voltage: 300Vrms
Reference Conditions: 23C Ϯ1C, 30% to 60% Relative Humidity
Overload Protection: Up to 500V peak momentary on all ranges
Size: 7" x 5-1/4" x 3-1/8"
Weight: 3 Ibs. (1.4 Kg)
Battery: One 9V NEDA No. 13F, 1604A (Burgess Type PM-6 or Equivalent)
Specifications subject to change without notice.
Any discussion in this document regarding UL, ANSI or IEC specifications is
for Reference purposes only. The input network utilized in the M229-2 is
detailed in Figure 1 on Page 3 of the manual. The customer is advised to
obtain the latest specification from the rating agency.
NOTE: For specification information call ANSI at (212) 642-4900 or UL in
Northbrook, IL at (847) 272-8800.
Carrying Case accommodates the Tester, Test Leads and Operators Manual.
Ordering Information
LEAKAGE TESTER
229-2 Current Leakage tester
Catalog No.
12267
ACCESSORIES
Catalog No.
Probe leads w/ screw-on alligator clips 00125
Probe set, replaceable tip, banana plug 07538
Clip set, alligator, screw on
00425
Lead set, alligator, banana plug
07500
ACCESSORIES
Case, Yellow Padded Nylon
Case, Black Padded Nylon
Case, Hard Leatherette Front Load
Case, Molded Plastic
Catalog No.
00832
00834
00805
45028
rev_2 6/09