2935 Datasheet, PDF (1/1 Pages) KR Electronics, Inc. – 71 MHz Center Frequency

IoT CONTROL RELAY
Safely control AC power from logic.
Build the IoT. Connect easily and safely. Control power
from an Arduino, Raspberry Pi, Galileo or other micro-
controller. The universal input connects to any circuit
including 3.3V and 5 volt logic. No driver is requried.
Simply connect two wires. One to ground and one to
your control signal, such as an output bit on a micro-
controller.
The relay can also be controlled by an AC input voltage
of 12 to 120VAC. No changes or jumpers are required.
The internal circuitry is very power e cient, using
approximately 1/5W unswitched and 1.1W activated.
Applications include:
• IoT products, DIY gadgets, OEM test equipment
• Home and building automation
• Green power and energy conservation
• Kiosks, vending machines and signage controls
Multiple AC loads of up to 12 Amps total may be con-
trolled. Your imagination is the limit.
The IoT control relay is rugged and reliable, with US
design and QC. It ships fully assembled and tested with
a 1 year warranty. Single units are available on Amazon.
Call DLI for quantity discounts and overnight shipping.
Digital Loggers, Inc.
2695 Walsh Avenue, Santa Clara, CA 95051
Tel: [phone]
IoTrelay.com
• A single logic input signal controls one high-current
SPDT AC relay. This relay signal switches four AC
outlets in pairs: Two outlets are normally on. Two are
normally o .
• The universal control voltage 3-48VDC or 12-120VAC
allows control from virtually any micro or AC source.
• Self-contained design eliminates dangerous high volt-
age wiring and safety hazards.
• Safety features include:
Optical isolation -- eliminates shock hazard
Relay hysteresis -- prevents relay chatter
De-bounce protection -- extends contact life
LEDs -- verify input voltage and switch state
• A large 3600W MOV clamps surges for clean power.
• The durable SPDT control relay is rated at 30/40A,
400,000 operations at 12A resistive. At no load, the
estimated lifetime is 5.3 million mechanical operations.
• A 12A thermal safety circuit breaker switch prevents
overloads and adds supplemental protection.
• Recommended operating range: AC input 90-120VAC.
Current 0-8A with 18AWG power cords, 0-12A with
16AWG cord. Use14AWG for 12A spans over 10 feet.
• Input connector: C-13/C14. Output: 4x NEMA 5-15.
• Included cord: 24" C-13 to 5-15 16AWG. Cords up to 50'
length are in-stock in 14AWG.
• Indoor use only: -35F to 145F, 5-95% noncondensing.
© 1999-2016 DLI. US & foreign patents pending.