English
Language : 

28544 Datasheet, PDF (1/2 Pages) List of Unclassifed Manufacturers – Horizontal and building backbone cable
Product Datasheet
P/N 43177 Rev. 4
Page 1 of 2
Rev. 1/ 2002-11-20
Belden 7812ENH
Cat 6 UTP FRNC bonded
Application
· Horizontal and building backbone cable.
· Support current and future Category 6 and Category 5 enhanced applications, such as:
10 Base-T, 100 Base-T, 1000 Base-T (Gigabit Ethernet), FDDI, ATM
Key features and Standards
· General standards: ISO/IEC 11801 2nd edition (2002), EN 50173 2nd edition (2001),
ANSI/TIA/EIA 568-b.2 (2002)
Construction & Dimensions
· Construction:
· Conductor:
· Conductor diameter:
· Conductor insulation material:
· Diameter over insulation:
· Cross web
· Jacket material:
· Outer diameter:
Unshielded 4 twisted pairs
solid bare copper
AWG 23 (0,57 mm)
Polyolefine
1,05 mm
FRNC compound
FRNC compound
6,5 mm
Pair 1
Pair 2
Pair 3
Pair 4
White-Blue/Blue
White-Orange/Orange
White-Green/Green
White-Brown/Brown
Colour identification according to
IEC 60304
Electrical characteristics (at 20 ºC)
Nominal mutual capacitance at 1 kHz
Maximum conductor DCR
NVP - Nominal Velocity of Propagation
SKEW – Propagation delay difference (100 MHz)
Mean Characteristic Impedance 4-100 MHz1)
50 nF/km
77 Ohm/km
0.70 c
typical £ 15 ns/100m
100 ± 5 Ohm
1): According to cable requirements of ISO/IEC 11801 category 6, Sept. 2002.
General and environmental characteristics
Temperature range - operation
Temperature range - installation
Minimum bending radius - operation
Minimum bending radius - installation
Maximum pulling tension
Flame retardancy
Caloric value
Weight (approx.)
Maximum operating voltage
Maximum continuous current per conductor (25°C)
-20°C - +60°C
+0°C - +50°C
26 mm
52 mm
80 N
IEC 332-1
535 kJ/m
43 kg/km
48 V rms
1.4 A
ã Belden Wire & Cable B.V. Netherlands Tel. +31-(0)77-3878-555 - Fax. +31-(0)77-3878-488 - E-mail: sales.info@belden-europe.com
All rights are reserved. Reproduction in whole or in part is prohibited without the written consent of the copyright owner.
All printing errors are subject to correction. Technical specifications are subject to change without notice.