24-06L-TGG Datasheet, PDF (1/1 Pages) List of Unclassifed Manufacturers – UNLESS OTHERWISE SPECIFIED,

PART NO.
24-06L-TGG
ECN # REV
-
A
REVISIONS
DESCRIPTION
RELEASED
DRAWN DATE CHECKD DATE APPRVD DATE
Kavitha 04/9/07 Suresh 04/9/07 G. C 19/9/07
Specifications:
Bodies
: Brass per JIS-C3604.
Centre Contact : Brass per JIS-C3604.
Insulation
: PTFE per ASTM D1457 and ASTM D1710.
Crimp Ferrule : Brass per JIS-C2700
Connector interface per MIL-STD-348A.
Part to be clean and free of burrs.
Specification Table
Number
Description
1
Body
2
Insulation
3
Chassis
4
Centre Contact
5
Crimp Ferrule
Material
Brass
PTFE
Brass
This data sheet and its contents (the "Information") belong to the Premier Farnell Group
(the "Group") or are licensed to it. No licence is granted for the use of it other than for
information purposes in connection with the products to which it relates. No licence
of any intellectual property rights is granted. The Information is subject to change with-
out notice and replaces all data sheets previously supplied. The Information supplied is
believed to be accurate but the Group assumes no responsibility for its accuracy or
completeness, any error in or omission from it or for any use made of it. Users of this
data sheet should check for themselves the Information and the suitability of the prod-
ucts for their purpose and not make any assumptions based on information included or
omitted. Liability for loss or damage resulting from any reliance on the Information or
use of it (including liability resulting from negligence or where the Group was aware of
the possibility of such loss or damage arising) is excluded. This will not operate to limit
or restrict the Group's liability for death or personal injury resulting from its negligence.
SPC MULTICOMP is the registered trademark of the Group. © Premier Farnell plc 2007.
TOLERANCES:
UNLESS OTHERWISE
SPECIFIED,
DIMENSIONS ARE
FOR REFERENCE
PURPOSES ONLY.
Stripping Dimension
Dimensions : Millimetres (Inches)
Finish
Part Number
Gold 3µ” Minimum
None
Gold 3µ” Minimum
Gold 30µ” Minimum
Gold
24-06L-TGG
DRAWN BY:
Kavitha
CHECKED BY:
Suresh
APPROVED BY:
G.Cook
DATE:
04/09/07
DATE:
04/09/07
DATE:
19/09/07
DRAWING TITLE:
SIZE DWG NO.
A
SCALE: NTS
http://www.farnell.com
http://www.newark.com
http://www.cpc.co.uk
24-06L-TGG
M10000506
ELECTRONIC FILE
REV
1169648_DWG
A
U.O.M.: mm (Inches)
SHEET: 1 OF 1