2035O Datasheet, PDF (1/4 Pages) List of Unclassifed Manufacturers – DC Full/Half Step Drive w/ Oscillator

Applied Motion Products, Inc.
404 Westridge Dr.
Watsonville, CA 95076, USA
1-800-525-1609
Tel [phone]
Fax (831) 761-
6544
Product Datasheet
www.Applied-Motion.com
2035O
DC Full/Half Step Drive w/ Oscillator
Product Features
On-board oscillator
Full & half step
Idle current reduction
Screw terminal connectors
Dip switch setup
Analog speed adjustment
Tach output
Enable input (inhibit)
Optically isolated inputs
1pc. - 229.00
50pc. - 171.75
Description
The 2035O step motor driver is a full or half step drive, step phase sequencer with three state switching amplifiers
and optoisolated circuits. This drive has a built in ramping pulse generator (oscillator) with adjustable speed,
acceleration and deceleration. Oscillator speed range is 0-5,000 Hz. Speed can be set from on-board trimpot or
external pot.
A jumper allows you to select the internal oscillator. In oscillator mode, the pulse input becomes a run/stop signal:
when this signal is set high, the motor accelerates to a preset speed and slews. Lowering the input signal causes
the drive to decelerate to rest.
The amplifier regulates motor current by chopping at a constant, inaudible frequency. Phase current is selected
from 16 levels by a DIP switch.