2016A Datasheet, PDF (1/2 Pages) List of Unclassifed Manufacturers – INTEGRAL ELECTRONICS (IEPE) PIEZOELECTRIC ACCELEROMETER

Quality
Innovations
Customer Satisfaction
INTEGRAL ELECTRONICS (IEPE)
PIEZOELECTRIC ACCELEROMETER
• Outstanding Dynamic Range
• Wide Bandwidth
• Low Impedance Output
• Top Connector
• Stud Mounted
MODEL
2016A
Description
The VIP Sensors Model 2016A is a stud mounted piezoelectric accelerometer
designed for general vibration measurement on structures and objects. It features
a high signal-to-noise ratio, a high output sensitivity, and a wide bandwidth. The
accelerometer transmits its low impedance voltage output through the same cable
that supplies the constant current power.
The Model 2016A design is sealed against external contamination. Signal
ground is connected to the outer case of the unit. When used with an isolated
mounting stud, the accelerometer is electrically isolated from ground. The
accelerometer features a 10-32 top connector that is used with coaxial cable for
error-free operation.
VIP Sensors Signal Conditioner Models 5005, 5100 and 5102 are recommended
for use with this low impedance accelerometer.
1 0 -3 2
1 0 -3 2
0.4 6 ( 1 1.7 )
in (mm)
15.00
10.00
5.00
0.00
-5.00
0
Typical Amplitude Response
1
10
100
1000 10000 100
FREQUENCY
Typical Temperature Response
15
10
5
0
-5
-10
-15
-50
50
150 250 350
(-46)
(10)
(66)
(121) (1
TEMPERATURE °F (°C)
VIP Sensors
California, USA
Ph [phone]
Fx [phone]
[e-mail]
www.vipsensors.com
VIP Sensors reserves the right to modify
these specifications without notice. V01