10472 Datasheet, PDF (1/2 Pages) List of Unclassifed Manufacturers – 26.5MM ROUND - LOCATOR PINS BLACK

26.5MM ROUND - LOCATOR PINS BLACK
Status
Part no.
Drawing no.
No. of optics
No. of legs
Pin length
Related Optics
Related LEDs
Files
Production
10472
60475
1
4
4.3
10048 26.5 mm Narrow Spot Catadioptic
10124 26.5 mm Narrow Spot Catadioptic
10108 26.5 mm Medium Spot Catadioptic
10260 26.5 mm Wide Spot Catadioptic
10049 26.5 mm Elliptical Catadioptic
10224 26.5 mm Elliptical Orthogonal Catadioptic
10234 26.5 mm Elliptical Ramp Catadioptic
Lumileds Luxeon Rebel
Cree XLamp XP-E
SSC P5-II
Osram Oslon SSL 80 degree
Nichia Top Emitting NCSL 119-H3
SSC Z - Power Z5
LedEngin 5W
LedEngin 10W
Everlight Shuen
Everlight Shuen
Lumileds Luxeon Rebel ES
SSC Z - Power Z5P
Cree XLamp XB-D
Lumileds Luxeon T
Customer drawing (PDF)
Carclo Optics endeavours to continuously improve and renew its products; for this reason the technical data and contents of this catalogue may
undergo variations without prior notice. For correct and up to date information, Carclo suggest using the Opticselect tool on our website
http://www.carclo-optics.com.
Copyright © Carclo 2010
General Instruction - Optics & Holders
Handling instructions
q Do not handle or install lenses without wearing gloves, skin oils may damage the lens or the light transmission.
q Clean lenses with a mild soap and water and dry with a clean soft cloth.
q Do not use any commercial solvents on lenses.
q Mount holders with low Odour epoxies and allow time for them to out gas to stop lenses fogging.
Disclaimer - Optics & Holders
Please note that flow lines, weld lines, surface scratches and small black or white inclusions within the lenses are acceptable if the optical
performance of the lens is within the specification described below:
For optics that have FWHMs of 20 degrees or less, the general tolerance is +/-2 degrees OR the tolerances stated below - whichever is the
greater.
For all optics except Rippled and Frosted;
q FWHM = Datasheet Value +/-10%.
For all Rippled and Frosted Optics;
q FWHM = Datasheet Value +/-20%
For all Optics;
q Efficiency = Datasheet Value +infinity / -10%
CaTrhceloyOepllotiwcsin1g0/3bBrouwckniinngghoafmpoAlyvcea, _{rSblonuagthe, lBeenrskesshairned,} ShLo1ld4ePrsFcEaNn GocLcAuNr Ddue _{to the natural ageing process and exposure to heat and UV and as}
Tel: [phone] Fax: [phone]
Page 1