MKP3386Y2 Datasheet, PDF (9/17 Pages) List of Unclassifed Manufacturers – Interference suppression film capacitors

BCcomponents
Interference suppression film capacitors
Product specification
MKP 338 6 Y2
CONSTRUCTION
Description
• Low-inductive wound cell of metallized polypropylene
(PP) film, potted with epoxy resin in a flame-retardant
case
• Radial leads, solder-coated
• Small stand-off pips allow removal of solder flux etc.
during cleaning of the printed-circuit board.
144x12(halfpage)
3 SECTIONS
metal spray layer
MKP metallised polypropylene film
SPECIFIC METHOD OF MOUNTING TO WITHSTAND VIBRATION
AND SHOCK
In order to withstand vibration and shock tests, it must be
ensured that the stand-off pips are in good contact with the
printed-circuit board:
• For pitches ≤15 mm capacitors shall be mechanically
fixed by the leads.
• For larger pitches the capacitors shall be mounted in the
same way and the body clamped.
SPACE REQUIREMENTS ON PRINTED-CIRCUIT BOARD
The maximum length and width of film capacitors is shown
in Fig.7:
• Eccentricity as in Fig.7. The maximum eccentricity is
smaller than or equal to the lead diameter of the product
concerned.
• Product height with seating plane as given by
“IEC 60717” as reference: h_max ≤ h + 0.3 mm or
h_max ≤ h’ + 0.3 mm.
connecting wire
CBA313
Fig.5 Construction for pitch = 7.5 mm.
144x12(halfpage)
2 SECTIONS
metal spray layer
144x12(halfpage)
eccentricity
bmax = b + 0.3 mm
lmax = l + 0.3 mm
CBA116
Fig.7 Lay-out.
MKP metallised polypropylene film
connecting wire
CBA312
Fig.6 Construction for pitch > 7.5 mm.
Mounting
NORMAL USE
The capacitors are designed for mounting on printed-circuit
boards. The capacitors packed in bandoliers are designed
for mounting on printed-circuit boards by means of
automatic insertion machines.
For detailed tape specifications refer to this handbook,
chapter “Packaging information”.
Storage temperature
• Storage temperature: T_stg = −25 to +40 °C with RH
maximum 80% without condensation.
RATINGS AND CHARACTERISTICS REFERENCE
CONDITIONS
Unless otherwise specified, all electrical values apply to an
ambient temperature of 23 ±1 °C, an atmospheric pressure
of 86 to 106 kPa and a relative humidity of 50 ±2%.
For reference testing, a conditioning period shall be applied
over 96 ±4 hours by heating the products in a circulating air
oven at the rated temperature and a relative humidity not
exceeding 20%.
2001 Jun 22
9