English
Language : 

JM60030-1MW14 Datasheet, PDF (9/9 Pages) Cooper Bussmann, Inc. – Up to 400 A Class J ferrule and knifeblade power distribution fuse blocks
Technical Data 10192
Effective June 2016
Class J ferrule and knifeblade power distribution fuse blocks
Installing/removing covers on 30 to 400 amp blocks
Install cover:
Position cover
over block and
push straight
down until it
snaps/clicks
into place.
Open cover:
Using both
outside handles,
pull straight up.
For larger conductors, trim center tab
at notch as show in detail A.
Trim tab
here
A
Detail A
Installing 30 and 60 amp blocks on a 35mm DIN-Rail
1. Place one edge of DIN-Rail into
rail clips on one side of the block.
2. Rotate and push block down
to deflect rail clips.
3. Continue rotating block
until remaining rail clips
snap into place.
The only controlled copy of this data sheet is the electronic read-only version located on the Eaton network drive. All other copies of this document are
by definition uncontrolled. This bulletin is intended to clearly present comprehensive product data and provide technical information that will help the
end user with design applications. Eaton reserves the right, without notice, to change design or construction of any products and to discontinue or limit
distribution of any products. Eaton also reserves the right to change or update, without notice, any technical information contained in this bulletin. Once
a product has been selected, it should be tested by the user in all possible applications.
Eaton
1000 Eaton Boulevard
Cleveland, OH 44122
Eaton.com
Bussmann Division
114 Old State Road
Ellisville, MO 63021
United States
Eaton.com/bussmannseries
© 2016 Eaton
All Rights Reserved
Printed in USA
Publication No. 10192 — BU-MC16067
June 2016
Eaton, Bussmann, Low-Peak and Limitron are
valuable trademarks of Eaton in the U.S. and
other countries. You are not permitted to use
the Eaton trademarks without prior written
consent of Eaton.
CSA is a registered trademark of the Canadian
Standards Group.
NEC is a registered trademark of the National
Fire Protection Association, Inc.
UL is a registered trademark of the
Underwriters Laboratories, Inc.
For Eaton’s Bussmann series
product information,
call 1-855-287-7626 or visit:
Eaton.com/bussmannseries
Follow us on social media to get the
latest product and support information.
9
Eaton.com/bussmannseries