D11EN6FPG Datasheet, PDF (7/8 Pages) List of Unclassifed Manufacturers – D11 Expert Series, Visible Green, Blue or White LED Light Source

D11E Series Sensors – Visible Green, Blue or White LED Light Source
Cabled models
Dimensions
Slide Up
to Release
Fibers
Programming
Push Button
Power Indicator
Output Indicator
Signal Strength
Indicator
35.0 mm
(1.38")
29.0 mm
(1.14")
Mounting
Bracket
(Included)
Quick disconnect models
ø 1.0 mm (0.04 in)
Plastic Fiber
Emitter Port
ø 1.0 mm (0.04 in)
Plastic Fiber
Receiver Port
17.6 mm
(0.69")
64.1 mm
(2.53")
Slide Up
to Release
Fibers
11.0 mm
(0.43")
Mounting
Bracket
(Included)
35.0 mm
Programming _(1.38")
Push Button
Power Indicator
Output Indicator
Signal Strength
Indicator
29.0 mm
(1.14")
17.6 mm
(0.69")
ø 1.0 mm (0.04" )
Plastic Fiber
Emitter Port
ø 1.0 mm (0.04")
Plastic Fiber
Receiver Port
64.1 mm
(2.53")
11.0 mm
(0.43")
79.0 mm
(3.11")
Mounting Bracket
5.5 mm
(0.22")
11.0 mm
(0.44")
8.6 mm
(0.34")
35.0 mm
(1.38")
25.1 mm
(0.99")
9.9 mm
(0.39")
2 x 3.5 mm
(0.14")
2 x ø 3.18 mm
(0.125")
25.6 mm
(1.01")
2 x C 'sink
ø 7.9 mm (0.31")
3.2 mm (0.13") deep
ø4.4 (0.18") thru
9.6 mm
(0.38")
2 x ø 3.25 mm
(0.128")
30.2 mm
(1.19")
4.8 mm
(0.19")
2.5 mm
(0.10")
5.0 mm
(0.20")
Plastic Fiber Installation:
1. Cut fiber ends per instructions
included with the fibers. Slide the
fiber gripper up (open). For 0.25 mm
or 0.5 mm diameter fibers, insert the
adapter (shown below) into the ports
as far as it will go.
2. All fibers: Insert the prepared plastic
fiber sensor ends gently into the
ports as far as they will go.
3. Slide the fiber gripper back down to
lock.
Fiber Adaptor
Adaptor (included) is for use with
0.25 mm (0.01") or 0.5 mm (0.02")
diameter fibers
DIN Rail Mounting
DIN Rail
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: [phone]
page 7