VCC1-A3A Datasheet, PDF (5/10 Pages) List of Unclassifed Manufacturers – 1.8, 2.5, 3.3, 5.0 volt CMOS Oscillator

VCC1 Data sheet
Table 4. Electrical Performance, 1.8V option
Parameter
Symbol Min
Typical Maximum Units
Frequency
Operating Supply Voltage ¹
f_O
0.048
172.000 MHz
V_DD
1.71
1.8
1.89
V
Absolute Maximum Voltage
-0.5
3.6
V
Supply Current, Output Enabled
I_DD
< 20 MHz
mA
5
20.01 to 70 MHz
15
70.01 to 96 MHz
20
96.01 to 125 MHz
25
125.01 to 172 MHz
30
Supply Current, Out disabled
Output Logic Levels
Output Logic High²
Output Logic Low²
Output Logic High Drive
Output Logic Low Drive
Output Logic High Drive³
Output Logic Low Drive³
Output Rise/Fall Time²
< 1.00 MHz
I_DD
V_OH
0.9*V_DD
V_OL
I_OH
2.8
I_OL
2.8
I_OH
8
I_OL
8
t_R/t_F
30
uA
V
0.1*V_DD
V
mA
mA
mA
mA
ns
200
1.000 to 20.00 MHz
4
20.01 to 50.00 MHz
4
50.00 to 90.00 MHz
3
90.01 to 172.00 MHz
2
Duty Cycle⁴ (ordering option)
SYM
45/55
%
Operating temperature (ordering option)
Stability⁵ (ordering option)
-10/70 or –40/85
°C
±20, ±25, ±32, ±50, ±100
ppm
RMS Jitter, 12kHz to 20 MHz
0.5
ps
RMS Jitter
2.2
ps
Output Enable/Disable⁶
V
Output Enabled
1.26
Output Disabled
0.5
Internal Enable Pull-Up resistor⁶
1
Mohm
Start-up time
10
ms
1. A 0.01uF and a 0.1uF capacitor should be located as close to the supply as possible (to ground) is recommended.
2. Figure 7 defines these parameters. Figure 8 illustrates the operating conditions under which these parameters are tested and
specified.
3. Overtone designs, output frequencies>35MHz.
4. Symmetry is measured defined as Vs, On Time/Period.
5. Includes calibration tolerance, operating temperature, supply voltage variations, aging and shock and vibration (not under
operation).
6. Output will be enabled if enable/disable is left open.
t_R
t_F
80 %
Vs
20 %
On Time
Period
Figure 7. Output Waveform
ID D
+
V DD -
. 1µF
. 0 1µF
4
1
IC
VC ⁺
-
2³
1 5pF
Figure 8. Typical Output Test Conditions (25±5°C)
Vectron International 267 Lowell Rd, Hudson NH 03051 Tel: 1-88-VECTRON-1 e-mail: [e-mail]