QA-1000HC Datasheet, PDF (4/6 Pages) List of Unclassifed Manufacturers – Full Featured Programmable Analog Supply Current Monitor

QA-1000HC
2A RANGE, 50 kHz BANDWIDTH
ATE DUT Supply
+
To analog
ATE input
+ 15V
QA-1000HC
- 15V
CL
VDD / VEE
GND
PIN DESCRIPTION
The QA-1000HC has a standard 16 pins wide DIL footprint.
Pin # Name
Type Function
1
NC
2
DUT
3
GND
4
VEE
5
DUT
6
DUT
7
JP23
Not Connected
O DUT supply pin
S Monitor ground
S Monitor negative supply pin ( -12V)
O DUT supply pin
O DUT supply pin
C Monitor configuration pin – common pin for JP2 and JP3
8
JP2 ⁽¹⁾⁽²⁾
Monitor configuration pin – JP2
JP2 and JP3 allow selecting the bandwidth of the module. If both JP2 and JP3 are
C
open (NOT connected) then the monitor operates with maximum bandwidth
(5MHz).
If JP2 is closed (JP2 shortened to JP23) then the bandwidth is limited to about
500kHz
9
JP3 ⁽¹⁾⁽²⁾
Monitor configuration pin – JP3
JP2 and JP3 allow setting the bandwidth of the module. If both JP2 and JP3 are
C
open (NOT connected) then the monitor operates with maximum bandwidth
(5MHz).
If JP3 is closed (JP3 shortened to JP23) then the bandwidth is limited to about
50kHz
10
NC
11
VDUT ⁽³⁾
12
VDUT ⁽³⁾
13
VCC
14
GND
15
VDUT ⁽³⁾
16
VIDD
Not Connected
I DUT supply reference input
I DUT supply reference input
S Monitor positive supply pin (+12V)
S Monitor ground
I DUT supply reference input
O Analog IDD output voltage
(1) JP2 and JP3 should be closed exclusively, only one of them might be closed for a given configuration, they must
not be closed at the same time (if not, cut off frequency will be 45kHz instead of 50kHz).
(2) For optimum performance, the connection between JP2-JP23 or JP3-JP23 must be as short as possible.
(3) The VDUT pin must be permanently connected to a voltage source and must not be left floating.
© Q-Star Test nv, 2003
Revision C - page 4 of 6
Due to continuous pursuit of innovation, the technical specifications listed are subject to change without notice.