HB16CKW01 Datasheet, PDF (4/6 Pages) List of Unclassifed Manufacturers – Distinctive Characteristics

Subminiature Pushbuttons Series HB
Plunger Position
( ) = Momentary
POLES & CIRCUITS
Connected Terminals
Throw & Switch/Lamp Schematics
Pole Model
Normal
Down
Normal
Down
Notes: Switch is marked with NO, NC, C, L.
LED circuit is isolated and requires
external power source.
SP
HB15
*HB16
ON
ON
(ON)
ON
1-3
1-2
SPDT
1 (COM)
3
2
(+)
(-)
* When in latchdown position for the alternate circuit, cap position is .051” (1.3mm) above the built-in bezel.
SHAPES
S _{.354” (9mm) Square}
C _{.354” (9mm) Round}
The bezel is an integral
part of the switch body.
The bezel is an integral
part of the switch body.
Panel Cutout & Mounting
Recommended Panel Thickness:
.020 ~ .197” (0.5 ~ 5.0mm)
(8.0) Dia
.315
Overtightening the mounting nut AT073
may damage the switch housing.
K _{Housing available in black only.}
HOUSING
CONTACT MATERIALS, RATINGS, & TERMINALS
W01 _{Silver Contacts}
Power Level
0.1A maximum @ 30V AC/DC
Solder Lug
The .039” x .079” (1.0mm x 2.0mm)
oblong hole accommodates one solid
or one stranded 20-gauge wire or two
22-gauge wires.
(2.0)
.079
(1.0)
.039
(5.0)
.197
(1.8)
.071
Thk = (0.3)
.012
PCB Mounting
Solder lug terminals are spaced
.100” x .200” (2.54mm x 5.08mm).
This enables PCB mounting which can be
accomplished by elongating PC board
holes to .080” (2.03mm).
NKK Switches • email: [e-mail] • Phone [phone] • Fax [phone] • www.nkkswitches.com
3-05