5962-90737 Datasheet, PDF (3/15 Pages) List of Unclassifed Manufacturers – MICROCIRCUIT, LINEAR, ANALOG SWITCH, MONOLITHIC SILICON

1.3 Absolute maximum ratings. 1/
Supply voltage between V+ and V- ........................................ 44 V dc
Supply voltage between GND and V-..................................... 25 V dc
Digital inputs range to V- ....................................................... (GND -0.3 V dc) to 44 V dc 2/
Digital input range V_S, V_D to V- ............................................ (V-) -2 V dc to (V+) +2 V dc
or 30 mA, whichever occurs first 2/
Current (any terminal except for S and D) continuous ........... 30 mA
Current (S or D) pulsed, 1 ms, 10% duty cycle ...................... 100 mA
Power dissipation (P_D):
Cases H and X, at +70°C .................................................. 421 mW 3/
Case P at +75°C ............................................................... 600 mW 3/
Junction temperature (T_J) ...................................................... +175°C
Lead temperature (soldering, 10 seconds ) ........................... +300°C
Storage temperature range .................................................... -65°C to +150°C
Thermal resistance, junction-to-case (θ_JC) ...........................See MIL-STD-1835
1.4 Recommended operating conditions.
Positive supply voltage (V+)................................................... +15 V dc
Negative supply voltage (V-) .................................................. -15 V dc
Logic supply voltage (V_L) ....................................................... 5 V dc
Ambient operating temperature range (T_A)............................ -55°C to +125°C
2. APPLICABLE DOCUMENTS
2.1 Government specification, standards, and handbooks. The following specification, standards, and handbooks form a
part of this drawing to the extent specified herein. Unless otherwise specified, the issues of these documents are those listed in
the issue of the Department of Defense Index of Specifications and Standards (DoDISS) and supplement thereto, cited in the
solicitation.
SPECIFICATION
DEPARTMENT OF DEFENSE
MIL-PRF-38535 - Integrated Circuits, Manufacturing, General Specification for.
STANDARDS
DEPARTMENT OF DEFENSE
MIL-STD-883 - Test Method Standard Microcircuits.
MIL-STD-1835 - Interface Standard Electronic Component Case Outlines.
______
1/ Stresses above the absolute maximum rating may cause permanent damage to the device. Extended operation
at the maximum levels may degrade performance and affect reliability.
2/ Signals on S_X, D_X, or IN_X exceeding V+ or V- will be clamped by internal diodes. Limit forward diode current to
the maximum current ratings.
3/ For case outlines H and X, derate above T_A = +70°C linearly at 5.26 mW/°C. For case outline P, derate above
T_A = +75°C linearly at 12 mW/°C.
STANDARD
MICROCIRCUIT DRAWING
DEFENSE SUPPLY CENTER COLUMBUS
COLUMBUS, OHIO 43216-5000
DSCC FORM 2234
APR 97
SIZE
A
REVISION LEVEL
C
5962-90737
SHEET
3