TAG-1035 Datasheet, PDF (2/2 Pages) List of Unclassifed Manufacturers – 5.8 to 6.4 GHz GaAs MMIC VSAT (C-BAND) Power Amplifier

TAG-1035
5.8 to 6.4 GHz GaAs MMIC Power Amplifier for VSAT (C-Band) Applications
Package Outline
PIN 1
3
5
Pin 3: RF Input
Pin 5: V_g
Pin 8: RF Output
10
Pin 10:V_d
8
PIN 6
Tolerance: .XXX ^± 0.005
Evaluation Circuit
GND GND
Vdd
C2
RF
50 OHM
IN
LINE
1
10
2
9
3 _TAG-1035 8
4
7
5
6
1.0 µf
GND
GND
50 OHM
LINE
RF
OUT
GND
C1
1.0 µf
GND
GND
GND
V6
Typical Biasing Configuration
PACKAGED
AMPLIFIER
RF Input ³
(50 ohms)
Input
V_g
5
Bypass
(1µF Typical)
GaAs
MMIC
470 pF
470 pF
10
V_d
Bypass
(1µF Typical)
8 _{RF Output}
(50 ohms)
External Components Required:
Bypass Capacitors: 1µ F, typical
50 Ohm microsrtip interface
Evaluation Board
Notes
1. Dual bias supply required.
2. DC supply sequencing or protection circuitry not included. See Amplifier Biasing Procedure
3. A 360 pF DC supply line decoupling capacitor is included on both V_d and V_g lines. (See typical biasing configuration shown above).
4. The last fixture or circuit should incorporate additional bypass capacity (25ufd) on the drain and gate bias terminals to prevent oscillations
caused by feedback signals.
5. Supply (drain and gate) wire/leads should be as short as possible.
6. Close placement of external components to the power amplifier is essential for stability purposes.
7. TET recommends the unit be soldered to DC and RF ground for best results.
8. Pin numbers indicated on outline drawing are for user information only. Units are not labeled with pin numbers.
9. MASK drawing for circuit board available on the Teledyne Wireless website at www.teledynewireless.com.
Teledyne reserves the right to make changes without further notice to any specification herein. “Typical” parameters can and do vary.
10/2001
www.teledynewireless.com
email: [e-mail]
1274 Terra Bella Avenue, Mountain View, CA 94043 • Tel: [phone] • Fax: [phone]