VT82C686B Datasheet, PDF (101/128 Pages) List of Unclassifed Manufacturers – PCI Super-I/O Integrated Peripheral Controller

'HOLYHULQJ 9DOXH ^{7HFKQRORJLHV ,QF}
I/O Offset 2D-2C - Global Control (GBL_CTL) ............RW
15-12 Reserved ........................................ always reads 0
11 IDE Secondary Bus Power-Off
0 Disable ...................................................default
1 Enable
10 IDE Primary Bus Power-Off
0 Disable ...................................................default
1 Enable
9 Reserved ........................................ always reads 0
8 SMI Active (INSMI)
0 SMI Inactive...........................................default
1 SMI Active. If the SMIIG bit is set, this bit
needs to be written with a 1 to clear it before
the next SMI can be generated.
7 LID Triggering Polarity
0 Rising Edge ............................................default
1 Falling Edge
6 THRM# Triggering Polarity
0 Rising Edge ............................................default
1 Falling Edge
5 Battery Low Resume Disable
0 Enable resume ........................................default
1 Disable resume from suspend when
BATLOW# is asserted
4 SMI Lock (SMIIG)
0 Disable SMI Lock
1 Enable SMI Lock (SMI low to gate for the
next SMI) ...............................................default
3 Wait for Halt / Stop Grant Cycle for CPUSTP#
Assertion
0 Don’t wait...............................................default
1 Wait
This bit works with Rx4C[7] of PCI configuration
space to control the start of CPUSTP# assertion.
2 Power Button Triggering Select
0 SCI/SMI generated by PWRBTN# rising edge
.....................................................default
1 SCI/SMI generated by PWRBTN# low level
Set to zero to avoid the situation where PB_STS is set
to wake up the system then reset again by
PBOR_STS to switch the system into the soft-off
state.
1 BIOS Release (BIOS_RLS)
This bit is set by legacy software to indicate release
of the SCI/SMI lock. Upon setting of this bit,
hardware automatically sets the GBL_STS bit. This
bit is cleared by hardware when the GBL_STS bit
cleared by software.
Note that if the GBL_EN bit is set (bit-5 of the Power
Management Enable register at offset 2), then setting
this bit causes an SCI to be generated (because setting
this bit causes the GBL_STS bit to be set).
0 SMI Enable (SMI_EN)
0 Disable all SMI generation.....................default
1 Enable SMI generation
VT82C686B
I/O Offset 2F - SMI Command (SMI_CMD) ................. RW
7-0 SMI Command
Writing to this port sets the SW_SMI_STS bit. Note
that if the SW_SMI_EN bit is set (see bit-6 of the
Global Enable register at offset 2Ah), then an SMI is
generated.
Revision 1.71 June 9, 2000
-95-
Power Management I/O-Space Registers