PE42540SCH Datasheet, PDF (1/2 Pages) List of Unclassifed Manufacturers – PEREGRINE SEMICONDUCTOR

5
4
3
2
1
J1
D
D
J2
RF1
17 _GND
18 _RF1
GND ⁸
RF2 ⁷
RF2
J4
19 _GND
GND ⁶
20 _GND
PE42540
GND ⁵
21 _GND
GND ⁴
J3
RF3
22 _GND
U1
GND ³
23 _RF3
RF4 ²
RF4
J5
24 _GND
GND ¹
R1
R2
C
1M
1M
J8
HEADER 14
22
44
11
33
R3
0 OHM
R4
0 OHM
66
88
10 ₁₀
12 ₁₂
55
77
99
11 ¹¹
R5
0 OHM
R6
0 OHM
J6
14 ₁₄
13 ¹³
C5
0.1uF
C6
0.1uF
C1
22pF
C2
22pF
C3
22pF
C4
22pF
C
J7
Through Line
B
NOTES:
High frequency performance is dependent on proper RF connector assembly. The following factors must be controlled for
optimum performance:
1. The connector should fit tightly against the circuit board edge, avoid gaps.
2. The center contact pin must lie parallel and flat against the circuit board, avoid gaps.
3. The contact pin should be centered on the circuit board signal trace.
4. Use a minimal amount of solder between the contact pin and signal trace. Do not allow excess solder to build up or
flow down the trace.
5. Clean all excess flux and other residue from launch area, especially between the trace and ground.
6. USE 101-0515-01 PCB.
7. CAUTION:
A
CONTAINS PARTS AND ASSEMBLIES SUSCEPTIBLE
TO DAMAGE BY ELECTROSTATIC DISCHARGE (ESD)
8. ALL TRANSMISSION LINES ARE:
15 MIL WIDTH, 10MIL GAPS, 8 MIL CORE DIELECTRIC
ROGERS 4003 ON TOP LAYER AND FR4 ON INNER AND BOTTOM LAYERS.
UNLESS OTHERWISE SPECIFIED
DIMENSIONS AND TOLERANCES
ARE IN INCHES AND
APPLY TO THE FINISHED PART
TOLERANCES ARE:
FRACTIONS DECIMALS
±
.XX ± .01
.XXX ± .005
DO NOT SCALE DRAWING
MATERIAL
FINISH
CONTRACT NO.
DRAWN
JEFF LUNDY
ENGINEER
MATT ALLISON
CHECKED
APPROVED
SIMILAR TO MARKING SYMBOL
ISSUED
5
4
3
B
PEREGRINE SEMICONDUCTOR
DATE
6-28-10
9380 Carroll Park Drive, Suite 100
San Diego, CA 92121
A
DATE
6-28-10 _{SCHEMATIC, PE42540 EVK PCB}
DATE
DATE
SIZE
CAGE CODE
DWG NO.
REV
102-0612 ₀₂
DATE
SCALE:
DATE
Sheet 1 of 1
2
1