HS40 Datasheet, PDF (1/1 Pages) List of Unclassifed Manufacturers – Tap / Die Set, M3 to M12, HSS

Tap and Die Set
Specifications:
Blow moulded case
Sets of high speed steel taps to DIN352 M3, M4, M5, M6, M8, M10, M12 in taper, second, plug lead
Tap wrench to suit all sizes
Ratchet wrench to suit up to 10 m / m
High speed steel dies to DIN352 M3, M4, M5, M6, M8, M10, M12
Diestock to suit all dies
Screw driver to be used on screws on diestock to secure dies
Metric thread gauge to check pitch of thread
Used for general engineering work
Ideal for workshop, garage maintenance workshops
Part Number Table
Description
Tap / Die Set, M3 to M12, HSS
Part Number
HS40
Important Notice : This data sheet and its contents (the "Information") belong to the members of the Premier Farnell group of companies (the "Group") or are licensed to it. No licence is granted for the use of
it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change without notice and replaces
all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use
made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make any assumptions based on information included or omitted.
Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or where the Group was aware of the possibility of such loss or damage arising)
is excluded. This will not operate to limit or restrict the Group's liability for death or personal injury resulting from its negligence. DURATOOL is the registered trademark of the Group. © Premier Farnell plc 2012.
www.element14.com
www.farnell.com
www.newark.com
www.cpc.co.uk
www.mcmelectronics.com
Page <1>
11/06/12 V1.1