D118EI Datasheet, PDF (1/2 Pages) List of Unclassifed Manufacturers – Low Cost, 1W High Isolation SIP DC/DC Converters

D100EI _Series
Low Cost, 1W
High Isolation SIP
DC/DC Converters
New Budget Saver!!
Key Features:
Electrical Specifications
Specifications typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice.
Input
Parameter
Conditions
Min. Typ. Max. Units
● 1W Output Power
5 VDC Input 4.5 5.0 5.5
● 3,000 VDC Isolation
● Miniature SIP Case
● Single & Dual Outputs
● >1 MHour MTBF
● 24 Standard Models
● LOWEST COST!!
Input Voltage Range
Input Filter
Reverse Polarity Input Current
Output
Parameter
Output Voltage Accuracy
12 VDC Input 10.8 12.0 13.2
24 VDC Input 21.6 24.0 26.4
Internal Capacitor
0.3
VDC
A
Conditions
Min. Typ. Max.
±1.0 ±3.0
Units
%
Output Voltage Balance
Dual Output , Balanced Loads
±0.1 ±1.0
%
Line Regulation
For Vin Change of 1%
±1.2
%
Load Regulation (Note 1)
See Model Selection Guide
Ripple & Noise (20 MHz) (Note 2)
50
75 mV P - P
Output Power Protection
120
%
Temperature Coefficient
±0.02 ±0.03 %/ºC
Output Short Circuit
Momentary (1.0 Sec.)
General
Parameter
Conditions
Min. Typ. Max. Units
Isolation Voltage
60 Seconds 3,000
VDC
Isolation Resistance
500 VDC 1,000
MΩ
Isolation Capacitance
100 kHz, 1V
60
pF
Switching Frequency
100 150 200
kHz
Environmental
Parameter
Conditions
Min. Typ. Max. Units
Operating Temperature Range
Ambient -40 +25 +85
ºC
Operating Temperature Range
Case -40
+90
ºC
Storage Temperature Range
-55
+125
ºC
Cooling
Free Air Convection
Humidity
RH, Non-condensing
95
%
MicroPower Direct
232 Tosca Drive
Stoughton, MA 02072
USA
T: [phone]
F: [phone]
E: [e-mail]
W: www.micropowerdirect.com
Physical
Case Size
Case Material
Weight
Reliability Specifications
Parameter
MTBF
0.77 x 0.24 x 0.40 Inches (19.6 x 6.0 x 10.2 mm)
Non-Conductive Black Plastic (UL94-V0)
0.07 Oz (2.1g)
Conditions
Min. Typ. Max.
MIL HDBK 217F, 25ºC, Gnd Benign 1.0
Units
MHours
Absolute Maximum Ratings
Parameter
Conditions
Min. Typ. Max. Units
5 VDC Input -0.7
9.0
Input Voltage Surge (1 Sec)
12 VDC Input -0.7
18.0
VDC
24 VDC Input -0.7
30.0
Lead Temperature
1.5 mm From Case For 10 Sec
300
ºC
Internal Power Dissipation
All Models
450
mW
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.