ATS01N212QN Datasheet, PDF (1/2 Pages) List of Unclassifed Manufacturers – soft starter for asynchronous motor - ATS01 - 12 A - 380..415V - 5.5 KW

Product data sheet
Characteristics
Complementary
Assembly style
Function available
Power supply voltage limits
Power supply frequency
Power supply frequency limits
Output voltage
Control circuit voltage
Starting time
Deceleration time symb
Starting torque
Discrete input type
Discrete input voltage
Discrete input logic
Discrete output current
Discrete output type
Discrete output voltage
Minimum switching current
Maximum switching current
Display type
Tightening torque
ATS01N212QN
soft starter for asynchronous motor - ATS01 -
12 A - 380..415V - 5.5 KW
Main
Range of product
Product or component
type
Product destination
Product specific
application
Component name
Network number of
phases
Power supply voltage
Motor power kW
Icl nominal current
Utilisation category
Current at nominal load
Type of start
Power dissipation in W
Altistart 01
Soft starter
Asynchronous motors
Simple machine
ATS01
3 phases
380...415 V (- 10...10 %)
5.5 kW at 380...415 V 3 phases
12 A
AC-53B conforming to EN/IEC 60947-4-2
60 A at nominal load
Start with voltage ramp
124 W in transient state
4 W at full load and at end of starting
With heat sink
Integrated bypass
342...456 V
50...60 Hz (- 5...5 %)
47.5...63 Hz
<= power supply voltage
Built into the starter
Adjustable from 1 to 10 s
Adjustable from 1 to 10 s
30...80 % of starting torque of motor connected directly on the line supply
(LI1, LI2, BOOST)stop, run and boost on start-up functions logic <= 8 mA 27
kOhm
24...40 V
(LI1, LI2, BOOST)positive state 0 < 5 V and < 0.2 mA state 1 > 13 V and > 0.5
mA
2 A DC-13
3 A AC-15
(LO1)Open collector logic end of starting signal
(R1A, R1C)relay outputs NO
24 V (6...30 V)open collector logic
Relay outputs 10 mA 6 V DC
Relay outputs 2 A 250 V AC inductive load, cos phi = 0.5 L/R = 20 ms
Relay outputs 2 A 30 V DC inductive load, cos phi = 0.5 L/R = 20 ms
1 LED (green) for starter powered up
1 LED (yellow) for nominal voltage reached
0.5 N.m
1.9...2.5 N.m
10/8/2011
1