APS100DH Datasheet, PDF (1/2 Pages) List of Unclassifed Manufacturers – 18-36 VDC INPUT RANGE DC-DC CONVERTER HALF-BRICK POWER MODULES 100-150 WATTS SINGLE & DUAL OUTPUT

Advanced Power Solutions
18-36 VDC INPUT RANGE DC-DC CONVERTER HALF-BRICK POWER
MODULES 100-150 WATTS SINGLE & DUAL OUTPUT
APS100HD-24B-S&D SERIES
FEATURES:
n SINGLE & DAUL OUTPUT
n WIDE 2:1 INPUT RANGE
n 1500VDC ISOLATION
n STANDARD HALF-BRICK PACKAGE
n HIGH-EFFICIENCY POWER MODULE
n UNDER-VOLTAGE LOCKOUT
n DESIGNED TO MEET INTERNATIONAL
SAFETY STANDARDS
SPECIFICATION
INPUT SPECIFICATION
Input Range: Wide 2:1 Input DC Range 18-36Vdc.
Input Voltage: Nominal 24Vdc.
Input Current: Typ. 6.85A full load and 0.06A no-load
@ 24Vdc nominal input.
Input Fuse: Use external fuse.
Inrush Current: Peak 20A @ 24Vdc.
Input Filter: Pi-Network for EMI suppression.
Under-Voltage Protection (UVP): Lock-out activated at
17.8 Vdc input.
Input Reflected Ripple Current: 28.4mA pk-pk @24 Vdc.
Isolation Voltage: 1,500Vdc input-output.
Remote On/Off: TTL/CMOS-Compatible input control.
Logic input reference to -Vin.
Logic [1]/Open(or 2.4Vdc above -Vin)=ON.
Logic [0]/Short(or 0~0.08Vdc above -Vin)=OFF.
OUTPUT SPECIFICATION
Output Voltage: See Ratings Chart.
Output Current: See Ratings Chart.
Output Wattage: Typ. 100-150W continuous.
Line Regulation: Typ. 0.1%.
Load Regulation: Typ. ±1.0%.
Noise & Ripple: Typ. 120mV, peak to peak.
OVP: Built-in.
Adjustability: Factory set.
Overload Protection (OLP): Fully protected against
overload and short circuit. Typical 130% max. load.
Consult the factory for special OLP setting.
GENERAL SPECIFICATION
Efficiency: Typ. 83.8-87%, various with input.
Operating Temperature: -40 to +100°C (baseplate).
Switching Frequency: Fixed frequency 330K Hz.
Storage Temperature: -40 to +100 °C.
Circuit Topology: Forward Circuit.
Temperature Coefficient: 0.02%/°C.
Transient Response: Peak transient <220mV and recovers Humidity: Up to 95% RH, Non-Condensing.
within 1mS after 25% load-change.
Case: Aluminum baseplate.
Power Density: 36.0 Watts / Cubic inch.
Industrial Grade.
NOTE: (1) All measurements are at nominal input, full load, and +25°C unless otherwise spec.
(2) Line Regulation measured from High to Low Lines at full load.
(3) Load Regulation measured from Full-Load (F-L) to Half-Load(H-L)at nominal input.
(4) Correct fuse size by calculating the max. DC current drain at low Line input & adding 20-25% for desired fuse size.