9007B1 Datasheet, PDF (8/12 Pages) List of Unclassifed Manufacturers – 9007 Mill and Foundry Switches Conforming to NEMA A600 and UL508

References (continued)
Severe Duty Limit Switches
0
9007 Mill and Foundry Switches
Lever Arms and Replacement Parts
With Reset
Cable Operated
With Spring
Rod Type
Ball Bearing Type
Weld-On Type
1-Way Roller Type
Conveyor Side Guide
Style C
Base Plates
Style D
Style B
Cable operated
Arm
Steel roller Roller
Reference
Weight
Length
Diameter
Roller Position Width
Inches (mm) Inches (mm)
Inches (mm)
lb (kg)
1.5 (38.1)
0.75 (19)
None
None
9007Y3
−
2.5" (63.5mm) long with eyebolt 0.25 (6.3mm) I.D. instead of roller. 9007B27
−
Rod Type (used on conveyor systems or where unusual shapes are required)
Adjustable 0.75 (19)
(1) 0.19 (4.8) None
9007 R16 0.18 (0.067)
Adjustable 0.75 (19)
(2) 0.25 (6.3) None
9007R17 0.18 (0.067)
(1) Rod not included
(2) Key stock not included
Ball Bearing Type (for abrasive dust areas or with high speed cams)
1.5 (38.1)
0.75 (19)
Center
0.28 (7.1)
9007B16 0.15 (0.055)
Weld-On Type (used where a special operator is required to weld to lever)
3.5 (89)
0.75 (19)
None
None
9007G10 0.50 (0.186)
One Way Roller Type (used with reversible cams for one way operations)
1.5 (38.1)
0.75 (19)
Outside offset 0.25 (6.3)
9007D4
0.64 (0.238)
Conveyor Side Guide
8.44" (214.3) long with 1.5" (38.1) dia. 3.75" (95.2) Delrin roller
9007R21 1.63 (0.608)
8.44" (214.3) long with 0.88" (22.3) dia. 3.75" (95.2) Delrin roller 9007R22 1.42 (0.530)
Separate Base Plates (2)
Style
Mounting Holes
Reference
Weight
lb (kg)
A
None (1)
2934D32G1
B
End
2934D14G1 0.34 (0.126)
C
Side
2934D33G1 0.42 (0.156)
D
End
2934D34G1 0.36 (0.134)
(1) No mounting holes in base plate. Side mounting holes in switch case must be used.
(2) Acceptable wire sizes 14 – 18 AWG (2.08 – 0.823 mm²); recommended terminal clamp torque
13 – 16 lb-in. (1.46 – 1.80 Nkm).
Optional Conduit Threads
Description
Metric
M20 - 20mm (per B.S. 4568)
Example: 9007TUB4M11
Reference
M11
Weight
lb (kg)
Three Point Contacts — Ordering Information
Select Type number of desired contact operating sequence for standard contact switch.
Change the letter following “T” or “FT” as shown below.
Change:
U to Y
S to K
Contact Configuration Changes
From:
For example:
TUB1 changes to TYB1
TSB1 changes to TKB1
13