LXHL-BW02 Datasheet, PDF (7/18 Pages) List of Unclassifed Manufacturers – Luxeon Emitter

Absolute Maximum Ratings
Parameter
DC Forward Current (mA) ^[1]
Peak Pulsed Forward Current (mA)
Average Forward Current (mA)
ESD Sensitivity ^[2]
LED Junction Temperature (°C)
Storage Temperature (°C)
Soldering Temperature (°C) ^[3]
Table 5.
White/Green/
Cyan/Blue/
Royal Blue
350
500
350
135
40 to +120
260 for 5
seconds max
Warm
White
350
500
350
± 16,000V HBM
120
40 to +120
260 for 5
seconds max
Red/
Red Orange/
Amber
385
550
350
120
40 to +120
260 for 5
seconds max
Notes for Table 5:
1. Proper current derating must be observed to maintain junction temperature below the maximum. For more information,
consult the Luxeon Design Guide, available upon request.
2. LEDs are not designed to be driven in reverse bias. Please consult Lumileds' Application Brief AB11 for further information.
3. Measured at leads, during lead soldering and slug attach, body temperature must not exceed 120°C. Luxeon emitters
cannot be soldered by general IR or Vapor phase reflow, nor by wave soldering. Lead soldering is limited to selective
heating of the leads, such as by hot bar reflow, fiber focussed IR, or hand soldering. The package back plane (slug) may
not be attached by soldering, but rather with a thermally conductive adhesive. Electrical insulation between the slug and
the board is required. Please consult Lumileds' Application Brief AB10 on Luxeon Emitter Assembly Information for further
details on assembly methods.
Luxeon Emitter DS25 (4/05)
7