LMFLSP100 Datasheet, PDF (7/10 Pages) List of Unclassifed Manufacturers – Super Luminosity White LED

6/9
£ Precautions For Use
This device should not be used in any type of fluid such as water, oil, organic solvent, etc.
When washing is required, IPA should be used.
When the LEDs are illuminating, operating current should be decided after considering the
ambient maximum temperature.
LEDs must be stored to maintain a clean atmosphere. If the LEDs are stored for 3months or
more after being shipped from LUMIMICRO, sealed container with a nitrogen atmosphere
should be used for storage.
The LEDs must be dip soldered within seven days after opening the moisture-proof packing.
Repack unused Products with anti-moisture packing, fold to close any opening and then store in
dry place. The appearance and specifications of the product may be modified for improvement
without notice. These LEDs are sensitive to the static electricity and surge. It is recommended to
use a wrist band or anti-electrostatic glove when handling the LEDs. If Over voltage which
exceeds the absolute maximum rating is applied to LEDs, it will cause damage in LEDs and
result in destruction. Damaged LEDs will show some unusual characteristics such as
remarkably increased leak current, turn-on voltage becomes lower and the LEDs get unlighted
at low current.
£
Soldering Condition
Temp.()
5FNQ 
%JQ
.BY $
.BY $
TFD
1SFIFBUJOH
NBY
TFD
35
TFD
5JNF
.BY $
.BY $
TFD
TFD
˝ Solder Dip Conditions
The Immersion of leads into a solder bath
@MAX260 shall be to 5 seconds max.
˞ 3FGMPX $POEJUJPOT
Preliminary heating to be at 150
 max. for 2 minutes max.
Soldering heat to be at 240
max. for 5 seconds max.
5JNF
˟ 'PS .BOVBM 4PMEFSJOH
Not more than 5 seconds @MAX300, under Soldering iron.
LUMIMICRO CO., LTD