PD035VX1 Datasheet, PDF (6/25 Pages) List of Unclassifed Manufacturers – TFT-LCD Module

Note 5-1: Select left or right shift
PD035VX1
R/L DIO1
1
Input
0
Hi-Z
DIO2
Hi-Z
Input
Shift
Left to right
Right to left
Note 5-2: Latch the polarity of outputs and switch the new data to outputs
At the rising edge (LD), latch the “POL” signal to control the polarity of the outputs.
Note 5-3: Control whether the Data R0~G5 are inverted or not. (PVI suggests connecting to GND)
When “REV=1”, these data will be inverted.
EX: “00”→”3F”, “07”→”38”, “15”→”2A”
Note 5-4: Polarity selector for dot-inversion control. Available at the rising edge of LD.
When POL=1: Even outputs range from V1~V7, and Odd outputs range from V8~V14;
When POL=0: Even outputs range from V8~V14, and Odd outputs range from V1~V7.
Note 5-5:
1) Relationship between input data and output voltage
The figure below shows the relationship between the input data and the output voltage with the polarity.
The range of V1~V7 is for positive polarity, and V8~V14 for negative polarity. Please refer to the following
pages to get the related resister values and voltage calculation method.
Vout
VDD2
Gamma correction diagram
V1
V2
V3
V4
Positive polarity
V5
V6
V7
Vcom
V8
V9
V10
V11
V12
Negative polarity
V13
V14
Vss2
Input Data
00H 08H 10H 18H 20H 28H 30H 38H 3FH
The information contained herein is the exclusive property of Prime View International Co., Ltd. and shall not be
distributed, reproduced, or disclosed in whole or in part without prior written permission of Prime View International Co.,
Ltd.
Page:6