ISG510065 Datasheet, PDF (6/8 Pages) List of Unclassifed Manufacturers – CATV OUT-OF-BAND TUNER

PACKAGE INFORMATION MLP-28 (Units in mm)
ISG510065
1. Dimensions and tolerances conform to ASME Y14.5-1994.
2. All dimensions are in millimeters. All angles are in degrees.
3. N is the total number of terminals.
4. The terminal numbering convention shall conform to JESD 95-1, SPP-012. The terminal #1 identifier may be either a mold or
marked feature.
5. Dimension b applies to metallized terminal and is measured between 0.25 and 0.3 mm from terminal tip.
6. ND and NE refer to the number of terminals on each D and E side respectively.
7. Co-planarity applies to the exposed heatsink slug as well as the terminals.
REV. D
7/19/2004
6