CAT-6 Datasheet, PDF (6/6 Pages) List of Unclassifed Manufacturers – CAT-6 UTP SOLUTION

110 Cross-Connect Block Installation Step
Step 1:
Mount the wiring base and legs onto a
suitable mounting surface with the
necessary screws and hardware. Then
lace the cables through the appropriate
openings in the wiring base.
Step 2:
Strip off the cable jacket with the jacket
stripped tool.
Step 3:
Seating the wire in accordance with the
wiring schemes (see page No.57 to page
No.58) onto the wiring base.
Step 4:
Seating the conductors and trim off the
excess wire with the cutting edge of the
impact tool.
Step 5:
Insert an 4 pair or 5 pair of 110
connecting block into the head of the
impact tool.
Step 6:
seating the 110 connecting block with the
impact tool onto the wiring base.
8 _LAN