|
EM488M1644VTB Datasheet, PDF (5/17 Pages) List of Unclassifed Manufacturers – 128Mb (2M×4Bank×16) Synchronous DRAM | |||
|
◁ |
eorex
EM488M1644VTB
Recommended DC Operating Conditions
(VDD=3.3V±0.3V, TA=0°C ~ 70°C)
Symbol
Parameter
Test Conditions
ICC1
ICC2P
ICC2PS
ICC2N
ICC2NS
ICC3P
ICC3PS
ICC3N
ICC3NS
ICC4
ICC5
Operating Current (Note 1)
Precharge Standby Current in
Power Down Mode
Precharge Standby Current in
Non-power Down Mode
Active Standby Current in
Power Down Mode
Active Standby Current in
Non-power Down Mode
Operating Current (Burst
Mode) (Note 2)
Refresh Current (Note 3)
Burst length=1,
tRCâ¥tRC(min.), IOL=0mA,
One bank active
CKEâ¤VIL(max.), tCK=15ns
CKEâ¤VIL(max.), tCK= â
CKEâ¥VIL(min.), tCK=15ns,
/CSâ¥VIH(min.)
Input signals are changed
one time during 30ns
CKEâ¥VIL(min.), tCK= â ,
Input signals are stable
CKEâ¤VIL(max.), tCK=15ns
CKEâ¤VIL(max.), tCK= â
CKEâ¥VIL(min.), tCK=15ns,
/CSâ¥VIH(min.)
Input signals are changed
one time during 30ns
CKEâ¥VIL(min.), tCK= â ,
Input signals are stable
tCCDâ¥2CLKs, IOL=0mA
tRCâ¥tRC(min.)
ICC6 Self Refresh Current
CKEâ¤0.2V
*All voltages referenced to VSS.
Note 1: ICC1 depends on output loading and cycle rates.
Specified values are obtained with the output open.
Input signals are changed only one time during tCK (min.)
Note 2: ICC4 depends on output loading and cycle rates.
Specified values are obtained with the output open.
Input signals are changed only one time during tCK (min.)
Note 3: Input signals are changed only one time during tCK (min.)
Max.
75
1
1
20
15
7
5
45
35
110
150
2
Units
mA
mA
mA
mA
mA
mA
mA
mA
mA
mA
mA
mA
Recommended DC Operating Conditions (Continued)
Symbol
Parameter
Test Conditions
Min. Typ. Max. Units
IIL Input Leakage Current
0â¤VIâ¤VDDQ, VDDQ=VDD
All other pins not under test=0V
-0.5
IOL Output Leakage Current
0â¤VOâ¤VDDQ, DOUT is disabled
-0.5
VOH High Level Output Voltage IO=-4mA
2.4
+0.5 uA
+0.5 uA
V
VOL Low Level Output Voltage IO=+4mA
0.4 V
Dec. 2006
www.eorex.com
5/17
|
▷ |